Quantcast
Jump to content


2005 Suzuki Vinsion 500, stalls when i give it gas


klarson

Recommended Posts

My fourwheeler has always ran fine, but the other night when i was using it i shut it off and than started it back up a hour later and it started running terrible as soon as you give it gas. You can feather it along if the choke is on but still not running very good. any ideas????

Link to comment
Share on other sites

First thing I would try is draining the fuel and starting with fresh gas, you may just have some bad gas. I am assuming that the quad starts and idles fine, but as soon as you give it gas it runs like crap. If none of the other advise has helped, take the top off of the carb and look inside. Make sure that the spring, retainer and needle are all as they should be. I have seen problems with these carbs with the floating slide. The needle retainer breaks and slips up into the spring and doesn't hold the needle down anymore. So when you give it gas, the butterfly valve opens letting air throught the venturi, which lifts the slide valve. Since the needle may not be sitting in the proper position, it may be allowing the main jet to open too early, flooding the engine. If every thing looks ok in the top of the carb, take the float bowl off and make sure there is no debris in the carb pluggin things up.

Link to comment
Share on other sites

if you are running on reserve then there is a chance that the fuel filter is plugging up in the tank or your tank is actually lower and ther is not enough fuel supply to run the throttle. i agree with DD and drain the fuel system and clean the crap out of the tank, fuel pump, fuel filter. if that does not help then pull the carb out and clean it.

your friendly neighbourhood mechanic.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Gwbarm
      I generally use Non Ethynol fuel in all my small engines. I just got back from the gas station and that fuel has really increased in price since last year, I will continue to use it, even though its north of 1.00 a gallon more. That seems minor compared to cleaning and repairing carbs every year. 
      I was just curious as to what others are doing in regard to gas in their quads, i know a lot of the newer ones are fuel injected which shouldnt pose a problem, but i have had lots of problems with rust and jell forming in carbs when using ethynol fuel.
    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next
    • By justent_88
      Hello, im looking for some input on this situation i have. My 94 Mojave has no spark, and i have no idea what it is. Ive replaced/tested the magneto, the pickup coil, cdi, the ignition coil. Even the key and Killswitch. I haven't tested the harness its self, but i have tried another harness and still nothing. The only thing i can think of is the fly wheel itself. I have found a lot of metal shavings in the fly wheel and have cleaned it the best I could. But nothing happened afterwards. I am truly stumped here and hoping some of yous could shed some knowledge/ideas that could help get this thing to fire. 
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
×
×
  • Create New...