gasket valve cover DS650 2001 popped out whats worng????
-
Popular Now
-
-
Similar Forum Topics
-
By Topendcol
First issue was fuel pump wont start once ignition has been turned on. Replaced the pump as I had one on hand, than noticed no power so replaced the fuel pump relay as that was were i traced the power to. Still nothing so further inspection looks like signal is coming from the PCM (FLR B20) but not switching the the brown wire to the fuel pump. Ive checked the operation of the bank angle sensor and it appears operational. Fuses and wiring all appear OK. The engine stop relay also tests OK. Ive been through the repair manual and diagrams but to no avail. Fully stumped, any tips would be helpful. Thanks
Col
-
By Mikael
I recently bought and old Kazuma Dingo 150cc and to begin with it started just fine. Then, for no apparent reason, it wouldn't start. It turns the motor but fuel isn't getting to the spark plug.
As mentioned in the title I've since replaced the fuel filter, the carburetor, the ignition coil and the spark plug. Fuel comes into the carburetor but seems to go no further. Is it a vacuum problem? Does anyone have a good idea about how I could diagnose the problem? And how to fix it?
I don't know what year it's from, sorry.
Sincerely
Mikael
-
By Fiend_138
Just picked up a 2014(?) Chinese quad for my kids to play around on. I can get the quad to start up, but then it dies out when we get ready to take off. Do I just keep playing with the carb, or is there something else I should be looking at?
Also, what kind of amps should I be looking for in a replacement battery?
Thanks
-
By Freezeman
Thought i would share a fix that I came across. I was working on a 99 scambler 500, The customer complaint was that even with the fuel shut off the tank would slowly drain out onto the ground. First I found the fuel shut off was bad/ leaking/ dripping so I installed a new one thinking that would fix it. Then I ran it and and seen that the overflow was flowing fuel out from the bowl. So I cleaned the needle and seat and changed the float height to lower the fuel level in the bowl. Well... It still overflowed and flooded. So I bench tested the needle and seat with a pop off tester. I found that these newer style needle and seats just utilize an o-ring to install the brass seat into the carb.
The o-ring for the seat had hardened up allowing fuel into the float bowl from under the seat. New o-ring and problems solved.
-
By StolenATV
Our 2004 Polaris 600 Sportsman with Mossy Oak Camo Package and Warrin Wench was stolen during the night on 11/23/15 from Oxford, GA. The ATV was loaded onto our 5×10 trailer with wood and lift gate that was hooked to my husband’s truck for a hunting trip the following morning. We have two labs who never barked so we think this was someone who was watching our house and came prepared. This was left to my husband by his best friend who died earlier in the year. This four wheeler had a great deal of sentimental value and we are hoping it still may turn up if someone ever runs the VIN number,
The post Still Searching for Stolen 4wheeler – Sentimental Value appeared first on Stolen 911.
View the full article
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.