-
Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
-
Similar Topics
-
By GTX-Racer
I am interested on some easy trails to ride with a younger, new rider in the Pittsburgh region. Preferably further west near the airport.
-
-
By mbirt
Hey all,
Just picked up two dead mid-90's Kawasaki Bayou 220s for $250. Already have one running on starting fluid and it sounds healthier than expected. Moving onto a thorough carb cleaning and refurb of the brakes next. These are our first ATVs and we're excited to make family memories on simple, approachable machines on our newly acquired land.
In case anyone reads this, is it worth rushing to 10 posts here to get the Bayou 220 FSM if I already have a Bayou 250 FSM?
Thanks,
Matt
-
By Params_sweden
Hi!
I got my KLF300 running again with your help a couple of months ago, at that time it was the ignition coil that had failed. It has been in use since then without issues until two weeks ago.
When the new issue showed I was going at about 10km/h and it suddenly slowed to a halt. I started it again after that with choke and I drove it 400 meters and parked. Next time it was really hard to start, and since it was low on gas I thought that was the problem. It didn't get any better with a full tank, so I assumed it was the cold weather, and adjusted the pilot slightly.
After that it I actually got it started again with full choke and some slight gas, I drove about 300 meters and then it slowed down to a halt again. After that, it hasn't started again.
The compression is 165psi. The spark has good intensity, the ATV has functioned before with the same spark "intensity"/light. I *assume* that it has gas as well, there is definitely gas on the spark plug when I remove it
I have checked the carburetor slightly, the float works, diaphragm looks ok, but I haven't disassembled it to really look for dust and such in all the small places.
My theory right now is that it might've been some dust in the gas tank that went into the system, it's just a theory
I'm thankful for all the help and pointers I can get, don't hesitate
/ Pär, Sweden
-
By Gwbarm
My Yamaha Big Bear shifts through all the gears good, goes into reverse smoothly, but when i go to get out of reverse it takes a lot of effort to get it back to first gear, and even then it does not go very smoothly, have to pull up on the pedal really hard, anyone else ever had this problem. Any ideas would be greatly appreciated.
-
-
Similar Tagged Content
-
- 3 replies
- 1,548 views
-
-
Gallery Images
-
-
-
By monkey420, -
-
By Guest, -
By mike83, -
By blahhhh, -
-
By nemesis, -
-
-
-
By mike83, -
By Guest, -
By cjsservices, -
By Chomp, -
-
-
By trouble4fun, -
-
-
Recently Browsing 0 members
- No registered users viewing this page.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.