Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

dstoltey

1992 Kawasaki Bayou 220- blowing fuses

Recommended Posts

I have a 1992 Kawasaki Bayou, and every time I try to replace the fuse on the starter relay, it blows immediately. I have replaced the battery, and have exhausted all of my ideas. Any help is greatly appreciated!

Share this post


Link to post
Share on other sites


If you disconnect the starter, does it blow? Something is shorted out.

* Moved thread to Kawasaki Forum.

Share this post


Link to post
Share on other sites

Its gonna be a bugger to find, but you have a bare wire touching metal somewhere in the mist, slow and steady and you should find it.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Michael Kastanis
      Hey I have a Kawasaki 300 boyu and it die in 5 gear and can’t get in Neutral try rocking it and moved it back and forth but nothing can same one here help me pls

    • By Brother Buddy Gardner
      Hello everyone! I recently purchased this quad for a mere 300.00 and it is pretty clean for the year. I bought it from a guy who bought it in a storage unit. He didn’t know anything about it. I got it home and noticed it did not have an ignition coil for the spark plug. I bought the ignition coil, a new battery, new CDI box, new starter relay, new safety neutral relay, new carb and so on... I got it to turn over, but when I pull the plug and check for spark I have nothing.. it has a non factory starter button that works when I push it and turns the engine over no matter if the key or stop switch is on or off..not sure what that’s all about, but it does turn over..just no spark at the plug. Any help would be greatly appreciated! Thanks!
    • By izoneterror
      hello guys i have another question my klf 220 jumps straight into reverse without turning the leaver this concerns me because i dont want to knock it down into revers when going at a decent speed any advice  why this is doing this and how i can fix it ?
    • By Michael Rogers
      Anyone ever replaced the shifter shaft on one? Not sure on the year but assuming it is in the late 90's. Is it a huge task, splitting the case etc... thinking about buying it as my next project.
       
      Thanks
  • Similar Tagged Content

    • By 1911Neil
      I had a quad fall in my lap a couple weeks ago. The only things I knew about it was it was a Kawasaki Bayou 220, was in pretty rough shape and was free. I couldn't say no to a fun little project. I've been looking a different ATV forums gathering quite a bit of info and decided this was the one I wanted to join.
      Thanks to this forum, I found the VIN under about an inch of mud and cross referenced it to be a '98. It had been sitting outside for at least 5 years and was told it ran when parked, but had no brakes. Squirrels or mice had been chewing on the handlebar controls and it's generally just kind of beat up.
      So far, I've gone through the carb (not near as bad as I expected), freed up the brakes (will probably need new cables), replaced the spark plug, air filter, petcock and put a new battery in it.
      The gas tank had been empty and looked clean so I put some fresh gas in it and tried to crank it today. I got a neutral light, but the starter button did nothing. I tried pull-starting it and it wouldn't fire. I checked the plug and wasn't getting a spark. I started digging and found some potential issues and some definite problems.
      I have a wiring diagram I found on here but it's just a picture or scan out of a book and hard to read. I don't see a reference to a black/yellow wire, which is my first problem.
      First, it that a factory crimp? One of those wired looks like it goes to the connector in the 2nd pic. Is that just a spade lug type connector? I pulled on it with some needle nose pliers but it didn't seem to want to come off. In the 3rd pic, should there be a fourth wire?
      I've read through and bookmarked the threads Andrew Baker and Arizona have going but I figured I needed to start with these obvious issues first. I have lots of pictures, so if there is something else you want to see, just ask. If I don't already have a pic, I'll take one.
       



    • By tomlad
      hi all first post  just found forum and the manuals / wiring diagram BIG THANK YOU
      im struggling to find the vin number on my frame? I m told left side of frame , lower, nr. in front of the gear pedal ?? haven't found it yet , is it numbers stamped on the frame or a commission plate ??
      main prob. no spark no power to coil , off to study the wiring info I've just found
      thanks again. tom
    • By Rich Arno
      Hello. I'm new so I hope I'm posting in the right place. My neighbor gave me a nice looking Bayou 220, but I can't get any fire to the plug. No lights, nothing. So far I've put in a brand new battery and relay. So those are good for sure. No neutral light comes on when the key is turned. Where should I start to try to figure out this electrical problem? I have a new coil to install, but common sense tells me it has to be something before that. I'm cheap so taking it to the dealer is out of the question. Does anyone know the process of elimination in a situation like this? I'd might add it LOOKS like the wires are all where they belong, but I can't say they are for sure. If the machine wasn't in such great shape, I wouldn't bother, but the grandkids should have a lot of fun on this. Thank you in advance for any help someone can offer.
    • By pizzaman_288
      How hard is it to change the outer seals on the rear differential mine are leaking fluid and I have no idea on how to change them out any help would be great thanks
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...