chinese 110 drive shaft

[flipper33]

Does anyone know how to dismantle the axle on a Chinese 110 atv I don't know extract model or the motor say united motors, I think it is a 110. I need to get at the rear gear and shaft out. The teeth are striped and I need to replace them. If you have a service manual or photos it would be great.

[swampcat07]

Not too sure but if you post a few pics I might be able to help.

[flipper33]

I put pictures on my profile page having trouble getting on forum page.

[swampcat07]

Once you take the "pumpkin" apart do you see any retaining clips? I would think that maybe the axel has to come out first and then the drive shaft but It was hard to excatally tell not working on these before.

[flipper33]

There was no clips inside or outside. I can't get the pumpkin to move. The ends behind the wheel hubs don't move, I not sure if this stuff is all pressed on. I wondering how hard it would be to change over to chain drive.

[marioweldinginc]

Its possible its pressed in or a taper fit. See if you can get em pressed. Try about a 10-20 ton press. Also can be a friction fit where one piece is heated then pressed into the second piece which is frozen

Sent from my SGH-T989 using Xparent Blue Tapatalk 2

[marioweldinginc]

Any update on the axles?

Sent from my SGH-T989 using Xparent Blue Tapatalk 2

[flipper33]

I was able to get the drive shaft out but, haven't got a press yet or the time to work on it.with my job I have a limited time to get stuff done.