Quantcast
Jump to content

Recommended Posts

Posted

So I got a 2003 arctic cat 400 in a trade it was sputtering a little so I drained gas and cleaned the carb. Ran good for about a day then started back. I took the carb off again and cleaned it, it had dirt in it again. While I had it off I soaked the air filter in gas and then blew it out and cleaned the intake. While I was waiting for stuff to dry I have seen where people run there snorkels straight from the carb and tun the air filter off the top of snorkel so out of curiosity I ran it like that and I made a mistake of not checking to see if my pipes had dirt in them well I ran it and after a minute or two it started smoking from the intake so I shut it off and there was sand around the inside of the intake and now it won't start back up I'm wondering what I could have messed up and what I can do to fix. Any help or advice would be greatly appreciated!!!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By randyoct
      Will the top end of a 400 fit a 366 the price is so much cheaper
       
    • By spigmef
      I bought a 2008 arctic at 366 with 120hrs. When i red line it in neutral is smokes blue a lot. When I put it in high range it has problems getting over 35km/h. I bought it and had to clean the carb. It ran ok after i cleaned it. Not I have this problem. 
    • By ath1981
      Got a 2011 425 EFI. It eat 2 belts, so I replaced the drive clutch assy, rollers, spacer and movable face. Put on a new belt and after 30 min of riding, it eat another belt. any clue what can be causing this?
×
×
  • Create New...