Quantcast
Jump to content

Recommended Posts

Posted

got a bayou KLF300B i believe it a 88 well i have put a new Carb and i have replaced the CDI/Rectifier/Coil/Spark plug/Reverse Cable/Diff Lock cable i have checked the stator/pickup coil and all the electrical also checked the timing and adjusted the valves it starts up easy but will not run without the choke on and wont rev past 1/4 throttle it also spits alittle gas out the back of the carb i took the new carb apart and everything is clear have tried loosing the exhaust to make sure it wasnt clogged it has a nice strong blue spark anybody have any ideas on what else to check

  • 2 weeks later...
Posted

hi, i have the same bike, i got it as a project bike. i have rebuilt it from the frame up. i had the same stuff going on with mine, i had to replace the timing chain, i had checked the timing and it looked good but the chain was so worn it was still off. when i put the new one on it stoped all the probloms.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By sandman001
      Just picked up a 2006 Dvx400. There is a switch I can't figure out what it is or where it goes. Has 3 wires (light blue, black and Yellow)

    • By marlon smith
      1990 kawasaki bayou 300c idles fine but pops out exhaust and intake when trying to excel, will not take throttle past 1/4 , any one had this problem?
      have replaced carb twice, same thing, fresh built engine cylinder head, same as before, new spark plug, flywheel key is good, pulser test good, good spark
    • By sandman001
      This 2006 ArticCat dvx400 didn't have a reverse cable. I got one and am wondering how it routes? If someone has a dvx400, could post a pic of there reverse cable routing, it would be greatly appreciated. Thanks
    • By Rockbottom
      anybody have a electrical drawing
      cant figure out problem
      new starter relay, when i turn the key on all 3 leads to relay are hot red, blue, blue white. Is that correct. nothing happens ir clicks at the starter relay when i push the start button
      on the relay closest to the cdi and nearest the brake light the relay vibrates as if it is opening and closing rapidly
      the batter is new and good
      if i short the B and M lugs on the starter relay the engines turns over but does not start and there is no spark
      I ordered a new cdi but the one on the machine is only a few months old but a aftermarket
      anybody have a electrical drawing or advice ir know what that relay symptom is and what activates it
      thanks ahead
       
       
    • By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 
×
×
  • Create New...