Quantcast
Jump to content

1985 Honda 200s ATC - Carb Question

Bclement30

By Bclement30
in ATC 3-Wheeler Forum

 Share

Recommended Posts

Bclement30 Rookie

Bclement30

Posted
Posted

I have replaced my oem carb with one that says its oem replacement (brand new). The problem I'm having is at idle it sounds like its sputtering like it wants to die out but when I'm on the throttle its running great. When I barley put my hand over the air filter hole it completely dies out. I have tried playing with the air screw adjusting it to the 2 1/4 turns out like the manual says and its still having the same problems. Can anyone point me in the right direction to help solve the problem. Now I bought a new one cause my old oem carb the idle screw on my original carb kept backing out. Please can someone help me I'm at my wits end at this point. Please help please

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Forum Topics

    • WeeBee
      Advice on ATV Trailer Brand?
      By WeeBee
      I'm looking at buying a New "CarryOn" 5'x8' Trailer with the Ramp Gate and Mesh Floor from my local Tractor Supply store ! Anyone have any experience with this Brand of trailer to share ?? Thanks!
    • Elk
      Throttle assembly spring replacement
      By Elk
      2002 Polaris Magnum 325
      How to replace throttle assembly spring?
    • Shorty51
      2006 Arctic Cat Utility transmission drive shaft replacement.
      By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • ButchM
      2023 Hisun Axis 700 fuel problem
      By ButchM
      Hisun 700 EFI. Replaced TMAP sensor had broken off . Fuel pump pressure 41psi. The only way I can keep it running (and runs fine) is to close off fuel return line. 
    • dkgg5755
      2003 Kawasaki bayou 250 carb problem
      By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...