Quantcast
Jump to content

Recommended Posts

Posted

Changed oil, removed and cleaned float, needle and seat, and carb, changed oil again, still, several gallons of gas seep I to crank case, any ideas please? Not very good at setting the float so I dread rebuilding the carb.

Posted

if you hold the carb upside down and level with the bowl off, measure the distance from the mating surface of the bowl to the top of the float, i think if you are at a half inch or less you should be good. there is a metal tab where the needle slides onto to the float to adjust if need be ...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By toe420
      I got a couple yamaha moto 4 225cc quads. The guy gave me several old starters with them. I see kits are available to rebuild them but does anyone have tips or tricks for doing it? I haven't rebuild a starter before so im not sure what to look out for. 
    • By tflack500tbx
      Background,
      This winter (Dec.) I was plowing and everything just died, just quit.  No lights, no pull start, No nothing.  I've had this problem before and I changed the voltage reg and it ran fine for over a year. Then this.  So I changed it again, thinking this was the same problem.  Tried to start it and a small pin hole in the CDI appeared with electrical smoke.  
      Months go by and I finally decide to just replace parts (I'm Horrible at electrical issues).  I changed the stator, new CDI, new Voltage reg, new starter solenoid, tested the starter (prefect), charged the battery.  
      Went to start it and the solenoid rapidly clicked.  All the dash lights on, headlights work.  Pull stared it and it fired right up no issues.  Looked into the rapidly clicking starter solenoid and it was not enough juice in the battery.  Took the battery completely out and hooked up a jump box to it turned the key, light on, everything looks good.  Pushed the starter button and it fired right up ran great.  Turned it off to test it again, Turned the key and nothing.  No dash lights nothing.  Took the jump box off and pulled started it.  Started it right up.  Re-hooked the jump box, still nothing.
      Any Ideas? 
    • By cruteg8
      Does anyone know forsure if u can swap out the Crank Case on a 2001 kawasaki Lakota 300 sport  with a kawasaki Bayou 300 Im seeing yes and no all over some say the mounting position is different so you can't swap the cases but everyother inernal engine part you can swap then im seeing no problem bolts right on can someone plz clarify who knows forsure 
    • By sunn
      Maybe someone has the answer to correct a long cranking but did start after maybe 10 seconds?
      Temp was mid 70's, with ATV not run for maybe a month but on battery maintainer with full bat charge noted.  The atv started, but then died a couple times after repeated attempts.  But when run awhile everything was ok.  Although when starting now I do hear the fuel pump humming but seems to take a few ,"long" seconds before full prime pressure.
      Is this typical of a failing fuel pump?
      I've priced a replacement fuel pump on eBay for less than $40 so am tempted to simply replace it for good PM.  Just had all covers off so looks really easy to replace.
      Any ideas?
    • By Damien911
      Setting the timing on a 2005 Yamaha 250 Bruin
×
×
  • Create New...