Quantcast
Jump to content

Recommended Posts

Posted

I brought my Arctic Cat into a local power sports store to have it serviced. because it would not fire up. they did a compression test and it read 33 PSI. the shop then did a valve adjustment which brought it up to 66 PSI, which is still too low. the shop called me after they messed with the valves and told me that they are going to have to take the top end off and look at it. they quoted me at $300. they think it needs a new valve seating but they cant be certain until they look at it. and I just cant afford to spend that much. the shop said its probably going to be $800 when everything is said and done. luckily I know a master technician that is willing to take the engine apart. I was wondering if anyone else had this problem, and where to begin?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By prdicon
      I was looking to buy a new ATV. 
      I was debating between Polaris sportsman 450 and Honda rancher.
      Polaris it a bit cheaper.
      But can you tell me which one will have more demand on the used market? Which one will keep it's value better?
       
      Let's say 3-5 years from now.
    • By LCP92
      Guys, I've got a 1999 Honda Foreman 450S.  It runs great, but smokes out the exhaust after startup until it warms up.  I'm thinking the valve seals are leaking.  I was wondering if there is a way to replace them without removing the head or if there's an oil additive that will recondition the rubber seals.  Any advice?
    • By Adamb2025
      I have a 1990 Honda fourtrax 300 2x4
      I rode the other day for 30-45 min. Switched it off and now it is completely dead..
      battery is fully charged, fuses are good . WILL NOT TURN OVER ,
      headlights won't turn on , No neutral, reverse or oil temp lights . Electrically it is completely dead !!! I replaced the key switch and CDI box , STILL NOTHING.
      I bypassed the neutral safety switch and grounded it to the battery and still nothing !! I used a jumper wire on the starter Solenoid , the motor will turn over but not start . I even bypassed both fuses and straight wired it to see if I could get a neutral light or headlights still nothing . What could it be ?
    • By randyoct
      Will the top end of a 400 fit a 366 the price is so much cheaper
       
×
×
  • Create New...