Quantcast
Jump to content

Recommended Posts

Guest jstemple
Posted

Sometimes gas will drip to almost steady flow out of the port in the bottom of the carb bowl. Ive taken the carb apart and bent the float, but still, from time to time, gas pours or just drips out. Any ideas?

  • 1 month later...
Guest jstemple
Posted

It was, I replaced the float needle and that didnt cure it, so I used a q-tip to clean the seat where the needle closes against and that did the trick.

Posted

Ethanol!

Shut the fuel off and let the carb run dry when done riding. That should help.

I (and alot of others) are switching to non ethanol gas because of this problem.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Travis_Smith
      I have a 2002 Kawasaki Prairie KVF 400 and im trying to figure out the actual float height... i have read 17mm +- 2mm, seen 13mm and 23mm... what is happening is it will start right up, rev a little and all is fine, when it warms and you put a load on it bogs down and sputters. no i don't have a manual
    • By DPDISXR4Ti
      I hadn't driven my Kodiak for a two months, and since it was low on fuel, the first thing I did was filled it up to maybe 7/8 full. Getting ready to start it, I rotated the fuel selector switch to "on" and within seconds I smelled and saw fuel dripping onto the floor. I quickly turned it off and the fuel gradually stopped - I can repeat this.
      The fuel is flowing from the hose that is connected to the bottom of the carb, and routes around to the left side toward the wheel well. Any idea what's going on here? It ran fine the last time I had it out.
      Thanks...
    • By Topendcol
      First issue was fuel pump wont start once ignition has been turned on. Replaced the pump as I had one on hand, than noticed no power so replaced the fuel pump relay as that was were i traced the power to. Still nothing so further inspection looks like signal is coming from the PCM (FLR B20) but not switching the the brown wire to the fuel pump. Ive checked the operation of the bank angle sensor and it appears operational. Fuses and wiring all appear OK. The engine stop relay also tests OK. Ive been through the repair manual and diagrams but to no avail. Fully stumped, any tips would be helpful. Thanks
      Col
    • By Ryan Menard
      Hi all,
      I have the strange issue where the float bowl drain screw on our ‘16 outlaw 50 is leaking by and letting fuel drain out of the tube.  It is not the overflow tube.  I have taken the carb apart to clean as well as taken the screw out and reinserted it but it still leaks by.  I can’t seem to find the screw alone for sale, all I can find is the whole float bowl for $100.  I would rather try a new screw first.  
      Does anyone know what screw will work in the factory carburetor and/or where to purchase one from?
      Thanks.
    • By psychodad
      Just rebuilt a 2006 Yamaha Big Bear carb for a friend and would like to double check the float height before I give it back to him  Anyone have a manual they could look it up in or a really good memory. 
      Thanks
      Jim
×
×
  • Create New...