Fullsizechevy9

Im having brake issues also does anyone know if the front brake calipers are rebuild able mine are frozen and i have the wet drum setup in the back where the plates are inside my rear diff with a lever and cable to put pressure on them how hard is that to rebuild

I have a 07 bb and im gettin no start at all solenoid is new i can turn it over by jumping the posts and push button seems to be sending signal to the solenoid any ideas?

Does anyone have a wiring diagram for a 07 bb 400 4x4 im trying to get my posts up to acc the downloads my bb wont start via push button i have traced everything and no chaffed wires or anything bad that i can find it will turn over via jumping solenoid posts i changed solenoid and made sure ground is good and voltage is good am I missing something i only see 1 ground which is from battery to frame is there supposed to be one from motor to frame also

Does anyone know if an 08 wiring harness will work on an 07 almost the same part number just a couple numbers off?

Im looking for an 07 big bear 4x4 400 wiring harness wondering if any other years or models will work thanks

Does anyone know where i can get a 07 big bear 400 4x4 wiring diagram and if i can use an older or newer model wiring harness as i cant find an 07 anywhere i have the 3plug cdi

Anyone know where i can find a 07 irs 4x4 bb 400 wiring harness or will the 08 work i can get those any idea on what harnesses will work?

I have an 07 bb 400 and when i hook up the ignition coil it keeps blowing the fuse i traced the wires cant find any shorts i also cant get the push button start to work it grounds and un grounds when pushed but dont turn over any thoughts?

Im having trouble finding a wiring harness for 07 4x4 big bear would an older harness work if i use the right cdi with it? Mine has the 3 plug cdi was hoping i could use a 2plug harness with a 2 plug cdi

I am having an issue with my 07 big bear when i hook up the ignition coil i keep blowing the 10amp fuse looked for shorts and cant find any. It also will not turn over the start button is working i tested it i put a new solenoid i have 1 hot and 2 grounds going into solenoid plug is this right?