Quantcast
Jump to content

Fmarshall04

Members
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

10 Good

About Fmarshall04

  • Rank
    Forum Beginner
  • Birthday 08/21/1976
  1. Fmarshall04

    Fmarshall04

  2. Got these months ago for 0$ they run great now a little TLC.... But who makes them? No identification on them at all!!! one is a 70cc other 90cc....THANX!!!!
  3. What is the hose for attached the exhaust pipe it is plugged into some kind of valve it's a 90cc Chinese atv still no idea who makes it
  4. Ok letting this unknown atv sit overnight it started and ran for 15 sec or so. So this should mean valve spec is ok set at .003, electrics work, why would an overnight rest do this? Yesterday I was getting spark, fuel into carb and to the cyl, so what gives?
  5. I have this NO NAME 90cc atv. Guessing that because of the 87ccm stamped on the jug. Any way I have spark,fuel getting through carb and into the cylinder. Valves are at .003. Double checked those. The remote control "board" is crap all corroded. It will 1 in ever 100 times think of starting, normally if I have left it alone. won't start on ether either. There is not a single ID marker on this thing. It does have the typical Honda knock off engine. I have the Honda Manual for that, but am out of ideas!!!!!!! the only other thing is there are 3 wires where a rear brake light used to be? or a kill sw. with key on 1 is hot the other 2 ???
  6. Found that the inside of the remote box was heavely damaged by water. Little capacitors etc were half rotted off rust corrosion bridged gaps that shouldn't be under the green board. Is this remote box needed, ie is it intertwined with the motors harness as a needed item or can it be bypassed or jumped still trying to get this thing running. Got spark and gas getting to cylinder, but no go yet.
  7. Just picked up what I believe is a Kazuma Meerkat 50. It has spark, fuel getting to plug, just will not fire up. It has no visible kiddy kill switch or rear brake light assemble. Not sure what the issue may be I'm used to my 2stroke atvs. Trying to get this up and running for my son. Are there any wiring diagrams out there or carb settings, ie the air fuel screw. Thanks
  8. Just picked up what I believe is a Kazuma Meerkat 50. It has spark, fuel getting to plug, just will not fire up. It has no visible kiddy kill switch or rear brake light assemble. Not sure what the issue may be I'm used to my 2stroke atvs. Trying to get this up and running for my son. Are there any wiring diagrams out there or carb settings, ie the air fuel screw. Thanks

×
×
  • Create New...