Search the Community
Showing results for tags ' trx400fa'.
Found 3 results
Hey guys I am new here but am having some problems. My 400 rancher AT is having trouble shifting from 1st to 2nd gear. I get a grinding and it seems like it is having trouble shifing gears. After it shifts into 2nd it is fine. Also it does it in Auto and Manual. Any thoughts?
Not sure that this really is a 2003, but that's the date on the label on the front of the chassis. Anyway, this is one of the electronic gear models with switchable auto or electronic shifting. The D-N-R is done with a level to the left of the fuel tank. After sitting out in the snow for a few weeks over Christmas reverse become very stiff to engage and often did not despite the level being in position. After riding for about 20 mins it seemed to fee up and engage. Now I'm having the same trouble even getting drive. I know the lever just pulls a cable which attaches to a metal tube down near the back of the footplate on the left hand side. This rotates a rod which I assume is linked in somewhere to the gear changing. I can currently change gear by getting a set of molegrips on that and turning it. I assume its that rod that'stiff and not the cable because the cable looks nice and clean. I will take the cable off and check, but it's the middle of lambing season right now and quad maintenance isn't top of my list. Any ideas what's inside the gear linkage and what might make it stiff, if it is stiff? The engine oil is clean and full, I don't think the gear case oil or diff oil would affect this? Any hints or tips very welcome. Thanks
Hello, I am new and not sure if I am posting in the correct area. It seems like my ATV's trans is slipping. I only use it to mow with a tow behind. When I turn sometimes there is a high pitched noise and ATV doesn't move. Does the clutch need to be replaced or are there any adjustments I can do? This does not happen when cruising. Thanks in advace.