Quantcast
Jump to content

  • Join Today, It's Simple and FREE!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

mad_jack_jr

2005 Arctic Cat 500 Lost My Spark - Need Help

Recommended Posts

I've changed my stator and pick up coil. I've verified new stator specs are correct and I have a good ground at the cdi. Also verified continuity from all stator wired to cdi and rectifier which is also new. I have a source voltage but no trigger voltage. It's a 2005 Arctic Cat 500 Suzuki Vinson motor. Any help would be GREATLY appreciated. I've spent about 2 weeks troubleshooting this and can't seem to find this exact scenario on any forum. Tjanx again for any input!

Share this post


Link to post
Share on other sites


Topic moved to Arctic cat forum and title changed to include ATV info and issue. ☺️ 

I'd have to look at a wiring diagram to the trigger to see if there is a relay that could cause you to stop at the trigger point. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

  • Similar Tagged Content

    • By mrfartsalot
      i have a 2001 suzuki quadmaster 500 4x4 that the primary cvt clutch is rusted on any ideas on how to get it off i want to try to reuse it if possible.
    • By Paul Maple
      I have a 1999 Sportsman  500, it was running fine, than started to lose power in the winter, I adjusted the idle screw and away I went, than a few weeks ago it died, I have found that i am flooding the engine, compression was at 70PSI and due to the compression release mech. i assume i am good as it compared to the same PSI on a 2000 sportsman 500 i have. i cannot start the atv unless i go full throttle and it starts an runs for about 30 sec than dies, again it is flooded. i ordered a new carb off ebay as i could get one for around $40. put that in same issue, i have checked the timing, (good), valves out of adjustment i adjusted to .006 still same issue, i have found the exhaust lobe and rocker arm to have some wear, i have ordered new ones, but am looking for any other input in this area as well. would the exhaust cam and rocker arm cause the engine to flood? i have used a bore scope and the piston liner has good cross hatching still? any input would be great.
    • By Alex Lee
      Im having a problem getting the left side of my engine case apart so i can fix my starter gear issue .can anyone share some guidance i have all bolts that i know or havent managed to remove hi lo shifter 
    • By Bobby Kitchens Jr.
      New arctic cat owner, I've read alot on the gauge issues, but let me say I have power, good ground, the aux also has power, the memory has correct voltage but no output of any kind. Only the LCD color works. I have also fully removed EVERYTHING and cleaned it all... what I still possibly have a cut wire knowing that I have good power to the back of the plug and good ground to the back of the plug but no outputs of any kind?
    • By Admin
      View File 2014 Arctic Cat 450 ATV Service Manual
      2014 Arctic Cat 450 ATV Service Manual
      Submitter Admin Submitted 02/08/2019 Category Arctic Cat ATV  
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...