Quantcast
Jump to content

Recommended Posts

Posted

I have 01 quad I do not think the battery is charging right.I have the one ground that charges the battery off an my meter shows it's putting out14.17 or .19 when I give it gas it go up to 14.20 or .23 my head lights stay the same

Posted

Some makes of quads and other  vehicles will run  without  a  battery, but  not all . It  depends on the  make and  model. Like  cars  and motorcycles, many  newer  quads  are  going all electronic so  some of them  won't  run  without the  battery. I cannot  say whether  yours will  or  not .

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Popular Now

  • Similar Forum Topics

    • By Mikey509
      Hey guys, so I've been messing with my quad, and between all the starts, the battery is dead. Is there a certain way to charge these? Can I just throw a trickle charger on it and call it a day? can i also jump it like a normal car with a battery pack or is that to much voltage 
    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By Adamb2025
      I have a 1990 Honda fourtrax 300 2x4
      I rode the other day for 30-45 min. Switched it off and now it is completely dead..
      battery is fully charged, fuses are good . WILL NOT TURN OVER ,
      headlights won't turn on , No neutral, reverse or oil temp lights . Electrically it is completely dead !!! I replaced the key switch and CDI box , STILL NOTHING.
      I bypassed the neutral safety switch and grounded it to the battery and still nothing !! I used a jumper wire on the starter Solenoid , the motor will turn over but not start . I even bypassed both fuses and straight wired it to see if I could get a neutral light or headlights still nothing . What could it be ?
    • By tds7
      The battery on my Big Bear drops completely down in the battery compartment nothing sticks up to grip too, plus there is only 1/8" clearance along the sides, no way to get a grip on it to pull up out of battery compartment. I thought about putting a piece nylon strap under the battery and leaving enough up each side to give me something to pull it up out ff the battery compartment or using a big zip tie around the battery.
      Any others have any ideas or have had this issue. 
       
    • By shorty
      FYI: I used a volt meter to test the stator/rotor output. Pulled the plug on the rectifier/regulator to access the 3 wires coming from the stator. The other 2 wires are 12v pos and negative so easy to identify the 3 stator wires, which are yellow on my Kowhockey. You should see around 30v AC not DC coming from the engine stator. Test all three wires to EACH OTHER not ground. Remember the stator puts out AC like an alternator. The rectifier converts the AC into DC to charge the battery. On my case the rectifier/regulator was bad, obvious because the 3 stator wires showed 30v AC
×
×
  • Create New...