Quantcast
Jump to content

Recommended Posts

Posted

2006 Arctic Cat 400 w/ 234 miles on it, sat for awhile, had it running in the fall then it just shut off, carb was cleaned, new fuel pump, new gas, new plugs, wont run! any ideas? I'm running out of things to check

Posted

First check spark from coil to plug. Another place, I just had a problem with fuel not flowing from gas tank valve, took it apart and screen was clogging the flow then started right up. Is it turning over? If not try pull start if you have one. It's almost always something simple. 

Posted

has plenty of spark,  turns over fine, i blew air back into tank thru fuel line, could hear it in the tank, im going to pull the fuel sending unit out and see if filter is plugged, yes. it's always something simple and stupid, running out of those things to check though!

  • Admin changed the title to 2006 Arctic Cat 400 Wont start/run

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By rjsummer
      Just some friendly advice on new tires. Check with your ATV dealer. 
      There are so many aftermarket sites, Revco, Royal Distributing, Partzilla, and on and on. Even with their “ big sales”, my local Canam dealer’s REGULAR price beat the tire prices of the 3rd party sellers! People often assume the Dealership will cost them more, but I found this not to be true!
    • By Johnnynv
      I recently bought a 2006 KFX  700 that had been sitting for 10+ years, started to replace the fuel system and the fuel pump has a connector that does not fit the same as original.  The plug has opposite slot as original.  There are two plugs on fuel pump bracket, some tiny sensor and fuel pump.  The new fuel pump plugs in the same place as tiny sensor, where as the old fuel pump plugged into opposite position.  I took old connector off bad fuel pump and repined it to new one, but now am questioning if this was the right thing to do.  I did pay attention to wire placement but just feel like there should be a direct replacement.  From the pictures on partzilla website, I cannot find a different option.  Has anyone run into this issue?
    • By Arizona
      Just recently bought a dead 06 Eiger, Can someone post or send me a wiring diagram for it:? 
      Need to check all wires, no power in most places, Cant seem to read the ones from online manual,
      too blury and cant tell wire color. Just too small. Thanks Az
    • By randyoct
      Will the top end of a 400 fit a 366 the price is so much cheaper
       
×
×
  • Create New...