Quantcast
Jump to content

2006 Arctic Cat 400 Wont start/run

Trink9899

By Trink9899
in Arctic Cat ATV Forum

 Share

Recommended Posts

Trink9899 Newbie

Trink9899

Posted
Posted

2006 Arctic Cat 400 w/ 234 miles on it, sat for awhile, had it running in the fall then it just shut off, carb was cleaned, new fuel pump, new gas, new plugs, wont run! any ideas? I'm running out of things to check

4tracker Enthusiast

4tracker

Posted
Posted

First check spark from coil to plug. Another place, I just had a problem with fuel not flowing from gas tank valve, took it apart and screen was clogging the flow then started right up. Is it turning over? If not try pull start if you have one. It's almost always something simple. 

Trink9899 Newbie

Trink9899

Posted
  • Author
Posted

has plenty of spark,  turns over fine, i blew air back into tank thru fuel line, could hear it in the tank, im going to pull the fuel sending unit out and see if filter is plugged, yes. it's always something simple and stupid, running out of those things to check though!

  • Admin changed the title to 2006 Arctic Cat 400 Wont start/run

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Forum Topics

    • LashinWheeler
      2006 Polaris Sawtooth No Spark
      By LashinWheeler
      Hello all, I have a 2006 Polaris Sawtooth with no spark. It has a dead battery but with a jump pack on it, it will still not Spark. Plug is good, Throttle ETC is not closed, Stator pick up coil seems to Ohm out in the correct range, Unsure how to properly check the CDI. And when ignition is on the Neutral and reverse light come on but after cranking just the neutral stays on. 
       
      Any help would be great,
       
      Thanks!
    • mehim
      NSFW / Looking for fun ideas for our 2nd Quad Runners event at our nudist campground
      By mehim
      Hi everyone and thanks for reading. 
      My husband and me are getting ready to host the 2nd Quad Runners event at our nudist campground. The first one (last year) went pretty well with about 20 quads attending and have to say, it was a smaller group, but they made up for their size with the large interest in partying and there was plenty of nudity as the Saturday night went on. 
      We have decided to host another one this summer, but we are looking for some fun (but safe) riding events. Our grounds are almost all flat and remember we are a nudist campground so many of us are bare as* naked so "slow ride" events would be the best. 
      Give us your thoughts and ideas and feel free to ask us anything you would like, and we will answer right here in the thread. 
      Thanks for your help and ride safe. 
      BTW, let us know what "anything goes" means for this thread section. 

    • tepin
      Багги Arctic Cat 700 инжектор 2008г пропала искра
      By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • Shorty51
      2006 Arctic Cat Utility transmission drive shaft replacement.
      By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • rjsummer
      Check your dealer for new tires..
      By rjsummer
      Just some friendly advice on new tires. Check with your ATV dealer. 
      There are so many aftermarket sites, Revco, Royal Distributing, Partzilla, and on and on. Even with their “ big sales”, my local Canam dealer’s REGULAR price beat the tire prices of the 3rd party sellers! People often assume the Dealership will cost them more, but I found this not to be true!

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...