Quantcast
Jump to content

Recommended Posts

Posted

This is why women should not take men shopping against their will.

After I retired, my wife insisted that I accompany her on her trips to WalMart.

Unfortunately, like most men, I found shopping boring and preferred to get in and out. Equally unfortunately, my wife is like most women - - she loved to browse. Yesterday my dear wife received the following letter from the local WalMart.

Dear Mrs. Samsel,

Over the past six months, your husband has been causing quite a commotion in our store. We cannot tolerate this behavior and have been forced to ban both of you from the store. Our complaints against Mr. Samsel are listed below and are documented by our video surveillance cameras.

1. June 15: Took 24 boxes of condoms and randomly put them in people's carts when they weren't looking.

2 . July 2: Set all the alarm clocks in Housewares to go off at

5-minute intervals.

3. July 7: Made a trail of tomato juice on the floor leading to the

women's restroom.

4. July 19: Walked up to an employee and told her in an official

voice, "Code 3 in Housewares. Get on it right away."

5. August 4: Went to the Service Desk and tried to put a bag of M&M's

on layaway.

6. August 14: Moved a "CAUTION - WET FLOOR" sign to a carpeted area.

7. August 15: Set up a tent in the camping department and told other

shoppers he'd invite them in if they would bring pillows and blankets

from the bedding department.

8. August 23: When a clerk asked if they could help him he began

crying and screamed, "Why can't you people just leave me alone?"

9. September 4: Looked right into the security camera and used it

as a mirror while he picked his nose.

10. September 10: While handling guns in the hunting department, he

asked the clerk where the antidepressants were.

11. October 3: Darted around the store suspiciously while loudly

humming the "Mission Impossible" theme.

12. October 6: In the auto department, he practiced his "Madonna look" by using different sizes of funnels.

13. October 18: Hid in a clothing rack and when people browsed

through, yelled "PICK ME! PICK ME!"

14. October 21: When an announcement came over the loud speaker, he assumed a fetal position and screamed "OH NO! IT'S THOSE VOICES AGAIN!"

And last, but not least

15. October 23: Went into a fitting room, shut the door, waited

awhile, then yelled very loudly, "Hey! There's no toilet paper in here!"

Regards,

Tom Richards

Walmart Manager

  • 3 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Callaway
      I am trying to diagnose a no spark issue with my 02 Big Bear 400 and I am really hoping it is not a CDI.  I have done the test on the stator and I believe that is faulty.  I ordered a new aftermarket one from a the jungle website and it tested bad right out of the box so I am waiting for a different one to arrive from an ATV parts supplier.  I started looking out of curiosity at CDI units and it seems if it is for a big bear you are SOL.  Kodiaks, no problem.  Big Bear. No such luck.  
    • By DaveswMN
      Pulled my '86 Moto4 out of shed where it sat for 20 years. I knew it smoked. checked it over a little put in gas and it fired right up!! 
      Drove about 100 yards, ran about half throttle wouldn't idle.  Put on somenew parts, jug/piston and rings, carb and valve seals.
      'went together ok, tuned it over by hand about 6 revs whick went well. Hit the starter it fired for about 6 revs and quit. tried it again fired once and then th sound of something slipping like maybe chain slipping over spoket.
      Took cover off to watch cam sproket, hit starter again, heard same noise and the cam sproket was not turning but jumping a bit. Chain was still tight. You will probably tell me I need to split the lower case but hoping there mightbe something else.
      I don't fully understand the chain tightener, the plunger only moves about 1/4 inch, should it move much more than that when off the motor and compressing it by hand?
      Thanks for any thoughts.
    • By McG75
      Sorry I suck at these forums so if you see this submitted under update status, my bad. Anyhow this is a new shock for a 96 Yamaha Kodiak 400 4x4 it fits my 96 Yamaha Timberwolf 250 4x4 perfectly. Little narrower are the bottom than the original but everything else is perfect. I extended it to almost a half in from full extension because I’m pushing 350 pounds.  It rides and hold me well. So if any of y'allRace driven shock. have been looking for one and didn’t want to do the research here it is. 





    • By p5200
      Hello folks, my machine wound up with I think water in the tank etc. It runs but speeds up and slows back down randomly. When not running I don't see gas dripping  from the drain nipple on bottom of float bowl and drain screw is closed tight. With normal idle speed I see no leaking. When the idle speed increases quite a bit on it's own, gas appears to start slowly dripping from float bowl drain nipple? I'm wondering if the carb is flooding and the gas is actually coming from higher up and just appears, to be coming out of nipple but, is actually running down the sides of the nipple? I put a kit in the factory Mikuni carb last year after sitting for a while and I think the gas in the jug I used had drawn moisture. I plan to pull the carb tomorrow and clean everything out. I was just curious if anyone else thinks it's probably something in the carb and is, acutally a flooding problem? Thanks Folks! 🙂
    • By kawasig
      Hello All
      I have a 1987 Suzuki dual range 230 and a 96 bayou 220. I'm trying to figure what oil to use. I normally put Amzoil synthetic in most everything. But I understand there are concerns over the wet clutch. I've heard rotella 10w40 full synthetic,5w40 synthetic,10w30&40 non synthetic. I do live in Michigan, so temps cold and hot are encountered. It could be below zero or 90 degrees farenhight. I don't have manuals for them. Any help is greatly appreciated!
×
×
  • Create New...