Quantcast
Jump to content


Oil drain plugs quadzilla 2008 320 e


Recommended Posts

That plug is usually up in one of the holes on the skid plate.  It’s definitely there so you are going to have to really get under it and feel around.  Even wash it out. I had a Yamaha with  a skid plate.  It was packed with dried mud.  After a little hosing down and looking I found it.   As far as the oil level there should be a sight glass or an indicator level on the oil plug almost like a dip stick but one or the other it’s there.   As far as oil a good 10w40 will be fine.  There was actually a topic on this today in the forum about oils.  Take a look.  

Be gentle with that oil plug when removing and reinstalling. You over tighten it and it strips or even worse crack the engine casing  where the threads are.  

  • Like 1
Link to comment
Share on other sites

That transmission plug should have a hex head flush type drain plug and it should be on the bottom same side as the fill cap.  Some of the engines on other manufacturers bikes had the gear boxes built right into the engine where the engine oil was also the gear box oil. Both pros and cons . I believe your bike has a separate transmission, locate the fill cap and look under the bike in the same area. 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By exalrod
      Hello All !
      I am looking for a service manual and wiring diagram for a 2005 50cc Polaris Predator 4 wheeler.
      Could anyone help with this?
    • By Werewolf
      Oil is getting in the air box from crankcase vent tube, I put the two hoses that go to the air box together then something started to smoke on the front of the engine. There is a filter? In the line I blew that out.
    • By JohnnyB
      Greetings, 
      Have a 88 LT80 that been sitting for a couple years. Bought a new piston, cylinder and head. Installed these, rolled it over and it quickly locks up.  Took carb apart. It was full of what appears to be 2 cycle oil. Cleaned it, but keeps locking up and 2 cycle oil continues to seap from exhaust port.  When i installed new cylinder, I noticed crankcase was full of oil.  I'm now wondering if that oil is what's getting sucked up into cylinder.  Should there be no oil in crankcase?  If that the case, how is crank and rod lubricated?  Sorry, never worked on a 2 stroke. Thanks!
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
×
×
  • Create New...