Quantcast
Jump to content

  • Join Today, It's Simple and FREE!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Recommended Posts

Got this terrapro recently. Has slight damage on left front fender-traight otherwise. Low hours-no smoke-runs excellent!! Finish mower comes with it. Mower has no issues. asking $1600. Always open to partia; trades. This is a neat machine that starts runs and drives very well!  If your interested shoot me a message  

IMG_20190710_094111.jpg

IMG_20190710_094029.jpg

IMG_20190710_094042.jpg

IMG_20190710_094049.jpg

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By mywifeknowseverythin
      I keep some people's phone numbers in my phone just so I know not to answer when they call.
    • By bradleyheathhays
      Damn, it took 30 years of driving to cause my first accident, and on Friday the damn 13th. Did a low speed rear end into the back of a lifted truck and got into it's trailer receiver. The only place it made contact with was at the very front center of the hood close to where it latches. Unfortunately the impact was enough that there's a longitudinal hump in the middle of the hood now, bowed 6 inches on each side above the quarter panels, which weren't involved at all thank God. Both my headlights are cracked at the top, but not because they got hit; I think it was because the hood and it's latch was pushed back during the collision possibly deforming the support structure, causing the to separate. The hood is lifted up about 3 inches above each headlight and when looking in at the support material just behind each headlight, one side shows cracks and the other cracks and about a 1/2 gap in the material. Can't tell but it may resemble fiberglass, not really sure? My best guess is that the whole front bumper is gonna have to come off and that entire front support piece be replaced. Any advice on how hard this can be? I do a lot of my own work but I really don't want to be getting into this especially with the weather getting so bad now.


      When I go junkyard shopping for parts, what year Tauruses are compatible with my '02?
    • By quadtech62
      I have a 02 Warrior i am trying to build a wiring harness i have looked in the manual and  i am confused... the pick up has 2 wires.  W/R W/G The source rotation coil has 2 wires. One is Red other is white/blue. The manual shows the  the white and blue wire connected to the w/g  right after the stator... so why is these 2 wires connected?  Does not show w/b wire at cdi 
      i have looked at many options with no luck if someone has a 2002-2004 warrior and can take a pic of the wires and location at cdi i would really appreciate it. Thanks
    • By Barry Troxtell
      I have a 2005 Sportsman 500, Instrument cluster will not illuminate, hi/lo beams work though.  Any tips or troubleshooting info is greatly appreciated!
    • By Christian Brindle
      I have a 2000 Polaris Sportsman 500. A year or so ago we got it running after replacing the kill switch. It ran great but after some use for a couple months it got a flat tire and for some reason we just forgot about it and it sat for some time. Before it sat i replaced the gas cap, fuel filter, fuel pump, petcock, battery, starter relay, oil and oil filter. I recently went to start it and it started so quickly and without choke or throttle but the ATV wouldn't move till about 1/4 throttle and it wasn't really a smooth ride until 1/2 throttle. it also would bog out randomly after you came to a stop and sounded like it was getting too much fuel. I cleaned the carb and adjusted the air/fuel screw to 1 3/4 turns out.  I also messed with the idle and the throttle cable adjuster up on the handlebars. It's safe to say it now runs worse than when i started working on it 2 days ago. It takes more effort to get started and bogs out idling after about 30 seconds. I tried adjusting the idle but every time i do it'll get to a sweet spot but after driving it down the driveway and back the idle will go up and down to the point where i can't put it in gear because the gears will grind. Any thoughts or ideas would be greatly appreciated. Thanks
  • Similar Tagged Content

    • By YamahaBB350
      I have a Yamaha Big Bear 350 and the reverse doesn’t work, it shifts from low to high easily but it won’t go back to reverse. I’m new to this stuff, so I’ll take any help. Any ideas? 
    • By Michael Aiken
      Where can I find a wiring diagram for my 2005 450 Kodiak. Thanks.
    • By ATVNetwork
      Introducing the 2020 Yamaha XT-R editions of ATV and Side-by-Side vehicles featuring exclusive XT-R features like a factory-installed Warn Winch, advanced suspension, special-edition paint and color-matched wheels with extreme terrain tires, all Assembled in the USA for unmatched Proven Off-Road capability, comfort, and confidence. 
      YXZ1000R SS XT-R: https://yamaha.us/yYXZXTR 
      Wolverine X2 XT-R: https://yamaha.us/yX2RSXTR
      Wolverine X4 XT-R: https://yamaha.us/yX4XTR
      Grizzly EPS XT-R: https://yamaha.us/yGrizXTR
       
       
    • By ATVNetwork
      Introducing the 2020 Yamaha XT-R editions of ATV and Side-by-Side vehicles featuring exclusive XT-R features like a factory-installed Warn Winch, advanced suspension, special-edition paint and color-matched wheels with extreme terrain tires, all Assembled in the USA for unmatched Proven Off-Road capability, comfort, and confidence. 
      YXZ1000R SS XT-R: https://yamaha.us/yYXZXTR 
      Wolverine X2 XT-R: https://yamaha.us/yX2RSXTR
      Wolverine X4 XT-R: https://yamaha.us/yX4XTR
      Grizzly EPS XT-R: https://yamaha.us/yGrizXTR
       
       

      View full post
    • By mrfartsalot
      i have a 1986 yamaha moto 4 200 and was wondering if i could put a 350 or 300 jug and piston on it to bump up the cc?
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...