Quantcast
Jump to content

Recommended Posts

Posted (edited)

Only have about 60 hours. Sometimes and most often when I just accelerate I'm hearing a metallic clunking noise that seems to coming below the gas pedal or towards the lower front section of the UTV. It does not sound horrible but it really does not sound good. It only lasts for about 1 or 2 seconds. Could anyone please give me any ideas what might be happening? Thank you.

Edited by daynick
Forgot Titlel
Posted

Sounds to me like a CV joint slipping.  Prob going to need an axle.  Not a huge deal to fix.  Make some tight U turns in both directions and see if you hear the clicking.   If so then its definitely an axle.  

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
    • By TomJulio
      I recently noticed my Fourtrax 2WD has 4WD wheels installed on the front.  The back spacing is significantly different than 2WD wheels and they are almost touching the strut springs and the tires actually do touch the springs..   So far, no luck locating 2WD wheels to correct this issue. 
    • By Olchap
      Hi, I am new to this forum I am currently working on my 1989 Yamaha front end.  The cv axles were bad so I changed them on both sides with all new wheel bearings. Now I'm looking at the front brakes and the 2 cylinders for the brake shoes on both sides do not work at all. I am also new at working on brakes so its a mystery to me what needs to be done to fix the cylinders.  Can somebody please help me with these brake issues? See the image below.
      Thank you,
      Olchap

    • By wjmedic
      Recently rebuilt front end on this Polaris 400. New axles, bearings, seals, control arm bushings, Hilliard clutch thoroughly cleaned and inspected with no damage noted. 
      Everything put back to together. Placed bike on jack stands all four wheels off the ground, started in 2 WD switched to AWD both front tires spinning, when AWD turned
      off right front wheel will not disengage from AWD. Checked voltage at connectors both left and right connectors have no voltage with AWD switch off, and both have 12.4V
      when AWD switch is turned on. Repeated turning switch on and off several times with no change in condition. I am thinking this must be something mechanical with the 
      Hilliard clutch on the right hub ie. weak spring or stuck rollers on the Hilliard clutch assembly (Is this a logical thought?) any ideas on trouble shooting this before I disassemble the 
      right front hub again 
    • By jannonballs
      2001 Yamaha Kodiak. Rebuilt and cleaned carb after sitting for 10 years. Got her runnin but now this clunking noise is happening and sometimes the engine stalls hard like the tranny or clutch abruptly stops the engine. This was not happening 10 years ago. Also the clunk will happen and the rpm's spike. See video. Any ideas before I tear into it?
      IMG_4791.mov
×
×
  • Create New...