2005 Yamaha Raptor 660 is Backfiring
-
Popular Now
-
-
Similar Forum Topics
-
By LMI
Hi all. New to the forum & quads. Seems like a great place full of info.
I just recently picked up a 2005 Suzuki KingQuad LTA700. I need a battery. I've been reading up on conventional vs AGM types. I have a Royal Distributing and Canadian Tire. RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140. Neither of these is the type from the manual FTZ16-BS.
from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS. How much does this make a difference for nearly x2 the cost?
And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
-
By tflack500tbx
Background,
This winter (Dec.) I was plowing and everything just died, just quit. No lights, no pull start, No nothing. I've had this problem before and I changed the voltage reg and it ran fine for over a year. Then this. So I changed it again, thinking this was the same problem. Tried to start it and a small pin hole in the CDI appeared with electrical smoke.
Months go by and I finally decide to just replace parts (I'm Horrible at electrical issues). I changed the stator, new CDI, new Voltage reg, new starter solenoid, tested the starter (prefect), charged the battery.
Went to start it and the solenoid rapidly clicked. All the dash lights on, headlights work. Pull stared it and it fired right up no issues. Looked into the rapidly clicking starter solenoid and it was not enough juice in the battery. Took the battery completely out and hooked up a jump box to it turned the key, light on, everything looks good. Pushed the starter button and it fired right up ran great. Turned it off to test it again, Turned the key and nothing. No dash lights nothing. Took the jump box off and pulled started it. Started it right up. Re-hooked the jump box, still nothing.
Any Ideas?
-
By Gtc4d
I recently purchased a raptor 80 for my grandson for christmas. I am trying to make sure it is running properly. i have rebuilt the carb and adjusted the carb idle then the mixture to middle of where it runs rough and it runs great for about a min or 2. then it stalls out. I can usually choke it and it will start so i feel it is lacking fuel. the fuel shutoff valve has been changed and i checked it for good fuel flow. any ideas of what to check next. I am planning to vfy fuel float height tomorrow. I visually checked it by turning carb upside down when i had it apart and it looked level. any ideas are appreciated.
Thanks.
Todd
-
-
By jordan_ATV
I got a 2005 350 Raptor Special Edition and I'm dealing with a no start issue; the weirdest thing is when I'm cranking it fires and slows down showing signs of pre firing, smoke shoots out the carburetor every time it sparks. every electrical part (CDI, Rectifier, Stator, Coil) has been swapped out from previous owner, the top end of the engines all new and I cleaned the carb out, anyone got any ideas or similar problems, also is it possible to have a bad spark timing
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.