Quantcast
Jump to content


Oil Changes


Recommended Posts

Ok, I'm not trying to start an out of control thread, however I am interested in how often and what products you use for oil changes.  On all my vehicles I change oil at least as often as recommended by the manufacturer and use the recommended products or better.  That is where the debate should get interesting.  On my '20 Polaris 850, I use the Polaris recommended oil and filter and change once a year or more often depending on hours of operation.  In my trucks, I use Mobil full synthetic until I get them over 100K then I'll use a blend or high mileage oil--Valvoline or Mobil or NAPA.  Since I'm in NM Montana I use 0W20 to 5W30. 

Would like to hear what you're using.

Link to comment
Share on other sites

I also run Mobile 1 in all my vehicles have for 20 plus years and like it very much. In my ATV I have stuck with mineral oil , only because mine are older and that's what was recommended for them at the time of production,  not sure if that's right or not, but that's what I do. I do stick with the manufacturers oil, only for peace of mind, because I feel like it is formulated right for their engines. Im sure there are probably better oils out there but yamalube has one of the best rating iv read, but I don't always believe everything I read, especially on the internet. One more thing I might add I did change one of my older vehicles to synthetic, a 99 V8, that had been using mineral oil since new and I noticed that it seemed to burn more oil than before, and synthetic to me seems thinner than the the same weight in mineral oil, so I switched it to high mileage synthetic and it even burned more oil, just my experience.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By JohnnyB
      Greetings, 
      Have a 88 LT80 that been sitting for a couple years. Bought a new piston, cylinder and head. Installed these, rolled it over and it quickly locks up.  Took carb apart. It was full of what appears to be 2 cycle oil. Cleaned it, but keeps locking up and 2 cycle oil continues to seap from exhaust port.  When i installed new cylinder, I noticed crankcase was full of oil.  I'm now wondering if that oil is what's getting sucked up into cylinder.  Should there be no oil in crankcase?  If that the case, how is crank and rod lubricated?  Sorry, never worked on a 2 stroke. Thanks!
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By BuckBilly
      Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
      Let's see if we can make this a daily event.
    • By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
    • By Slitzer
      How often do you change oil in front/rear diffrentials and gearbox?
×
×
  • Create New...