Quantcast
Jump to content


Anyone use Niche parts?


Recommended Posts

  • 1 month later...

I just put a Niche carb on a Bayou 220. What a difference from the other China carb that was on it. It would not idle before. And that was a new carb My Son put on. Now it idles good and runs like a whole different quad. Much faster. I'm impressed especially for  $29. I'm impressed!

Link to comment
Share on other sites

  • 3 weeks later...

Niche seems to be one of the better cheap parts manufacturers. I've had quite a bit of experience with their parts on Jetskis, mostly with a 1995 Yamaha Wave Venture 700. I tried a DB Electrical starter, it lasted about a month before it died- the front, heavily loaded bearing was not greased at all, and it just shredded itself and caused the rotor to contact one of the magnets and grenade.  I picked up a Niche one (which was actually half the price of the DB Electrical) and was pleasantly surprised to find it was better built, and had a proper roller needle bearing at the front end instead of a cheap bushing.  I've also had good luck with their starter relays, and ignition coils. I just put a set of tie rod ends on my new to me Quadrunner 250. They seem very high quality.  Definitely one of the few "cheap replacement parts" companies that seems to actually care about quality.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next
    • By Gwbarm
      I Ran across this video today comparing an aftermarket to OEM Carb on Suzuki Vinson, thought it might generate some interest, it is quite long but informative.
       
    • By HSTAR
      Hey I have a 1997 big bear 350 4x4
      I replaced the shifter shaft and the shift arm linkage and the rod when I installed them all I was unaware that you had to line the dot on the shifter shaft with the gap on the linkage arm gap put it all back  together and rode it I can't get it to shift in the right gears  I can move the shift cam by hand and goes in different gears but with the shifter shaft in it riding I can't put it in R or N 
      Anyone know how to line up the shifter shaft and the shift cam s
       
    • By ResQ91
      Hi guys
      My 87 Bear 350 won't start and could use a hand.
      Turn key on and Oil light turns on and then slowly fades out. (I think this is key to this) No start, not even a tick.
      battery and connections good
      A Solenoid post jump turns it over
      Neutral Safety Switch wire attached and seems good
      It has not had a wire/switch on Rear Brake Pedal ever since I had it.
      Any thoughts on some other things to troubleshoot this??
    • By jatho
      What is the best engine oil to use for the Suzuki King Quad - also any other tips and tricks I should know before doing an oil change on these bikes 
×
×
  • Create New...