Quantcast
Jump to content

Recommended Posts

Posted

http://www.motosport.com/offroad/product/QUAD-WORKS-POWER-KIT/?catalogId=109654&refine=1&catID=277&pcatID=265&catName=Intake&srchHistoryURL=kjj33zmx||parentCategoryID~264^superParentCategoryID~category_root^parentCategoryName~ATV^categoryID~265^categoryName~ATV%20Parts@vf8xmww8||parentCategoryID~265^categoryID~277^categoryName~Intake

Anyone use anything similiar to this? I'm wondering if its worth the 125.00 Dollars and if it would actually add a significant amount of power to my 04 raptor 660r?

Its a quad works power kit if the link thing doesn't work..

Posted

http://www.motosport.com/offroad/product/QUAD-WORKS-POWER-KIT/?catalogId=109654&refine=1&catID=277&pcatID=265&ca%20tName=Intake&srchHistoryURL=kjj33zmx||parentCatego%20ryID~264^superParentCategoryID~category_root^paren%20tCategoryName~ATV^categoryID~265^categoryName~ATV%%2020Parts@vf8xmww8||parentCategoryID~265^categoryID~%20277^categoryName~Intake

That's the direct link. Yeah, I'm gonna get one for mine. It's not the filter itself that gives the power. It's just a kit that comes with an air filter, pre-filter, and a jetting kit. Buy them all for cheaper than buying them individually.

Do you have an after market pipe? This kit will complete the intake/exhaust setup. Then you use the jet kit to dial in your carb to get the maximum power. You can even run no airbox lid because you will have the pre-filter.

Does that help?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Gtc4d
      I recently purchased a raptor 80 for my grandson for  christmas. I am trying to make sure it is running properly. i have rebuilt the carb and adjusted the carb idle then the mixture to middle of where it runs rough and it runs great for about a min or 2. then it stalls out. I can usually choke it and it will start so i feel it is lacking fuel. the fuel shutoff valve has been changed and i checked it for good fuel flow.  any ideas of what to check next. I am planning to vfy fuel float height tomorrow. I visually checked it by turning carb upside down when i had it apart and it looked level. any ideas are appreciated. 
       
      Thanks.
      Todd
    • By Adamb2025
      I have a 1990 Honda fourtrax 300 2x4
      I rode the other day for 30-45 min. Switched it off and now it is completely dead..
      battery is fully charged, fuses are good . WILL NOT TURN OVER ,
      headlights won't turn on , No neutral, reverse or oil temp lights . Electrically it is completely dead !!! I replaced the key switch and CDI box , STILL NOTHING.
      I bypassed the neutral safety switch and grounded it to the battery and still nothing !! I used a jumper wire on the starter Solenoid , the motor will turn over but not start . I even bypassed both fuses and straight wired it to see if I could get a neutral light or headlights still nothing . What could it be ?
    • By jordan_ATV
      I got a 2005 350 Raptor Special Edition and I'm dealing with a no start issue; the weirdest thing is when I'm cranking it fires and slows down showing signs of pre firing, smoke shoots out the carburetor every time it sparks. every electrical part (CDI, Rectifier, Stator, Coil) has been swapped out from previous owner, the top end of the engines all new and I cleaned the carb out, anyone got any ideas or similar problems, also is it possible to have a bad spark timing
    • By davefrombc
      Anyone  carrying  a power box when  camping with their ATV?  I built  a custom  one.  I  used a  marine  battery box that  has 2  50A Anderson Grey connector  outputs (  changed one of the greys to a red), an accessory socket  and2  USB outlets,and a battery  voltmeter ..  I  added a Pure sine wave 1,000w inverter to it and A red 120A Anderson connector to the  output  posts.. To  charge the  100Ah LiFePO4 battery  I  put in the box, I added  a DC to DC charge adapter that I  made input connectors for to allow charging the battery from a vehicle's  accessory socket  or a solar panel.   
      It  was a fun  project.. Besides  having a  1,000w power box for  120V ac , USB   and  12v accessories using the 10 A socket.  I  have  50  A  Anderson connectors  and the 120 A connector  to run  things like a  12v electric outboard   for fishing  trips .  The LiFePO4  battery  only allows a max output of 100A  so  it  can't be used for something like jump starting,  but  it  is half the weight and  delivers twice the capacity of a lead acid battery running accessories..  Commercial pow2er  boxes  don't  deliver  high draw 12v output to run things like  the  electric outboards.   That's one reason  I  custom  built  mine.   One box that serves for both camping and fishing.
       

    • By dkgg5755
      Im not getting 12v to ignition switch with key off or on I've jumped brown wire from starter relay to positive and neutral light comes on and push button start works. Can't figure out where to go from here any help appreciated l.
×
×
  • Create New...