Quantcast
Jump to content

Recommended Posts

Posted

HI everyone. I ride a raptor 660 2004. I just had a new clutch installed last summer. I didn't ride much the winter but a few times on the ice and mud. So now its spring and i took it out again but i noticed that the clutch isnt catching very well. I hope the new clutch isn't gone, but don't you need to adjust your clutch as you break in your new clutch? Any help would be appreciated thanks!

Posted

You should adjust the cable to reduce free play. There should be a minor adjustment at the lever on the handlebars. If you need a major adjustment, I believe further down the cable there is a an ajustment with lock nuts.

Posted
You should adjust the cable to reduce free play. There should be a minor adjustment at the lever on the handlebars. If you need a major adjustment, I believe further down the cable there is a an ajustment with lock nuts.

Exactly what AJMBOY said. Have you been able to adjust it?

  • 2 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Elk
      2002 Polaris Magnum 325
      How to replace throttle assembly spring?
    • By logray
      Hi all, 

      I am wondering if any of you have a Clutch Starter gear from a 1988 era quadrunner 250 sitting around that you could get me a precise measurement of the outer diameter of the race the sprag engages onto, for me? I need to machine a damaged race down and install a hardened sleeve and need that measurement (it's on a different gear than the OEM one, so I can't buy and use a OEM gear). 

    • By quadnut20
      Just picked up a 2025 Yamaha Kodiak 700 fixing to do a EPI Clutch mod to it since I dropped bigger tires on it !! Air box , exhaust , and programmer next ! 

    • By Gtc4d
      I recently purchased a raptor 80 for my grandson for  christmas. I am trying to make sure it is running properly. i have rebuilt the carb and adjusted the carb idle then the mixture to middle of where it runs rough and it runs great for about a min or 2. then it stalls out. I can usually choke it and it will start so i feel it is lacking fuel. the fuel shutoff valve has been changed and i checked it for good fuel flow.  any ideas of what to check next. I am planning to vfy fuel float height tomorrow. I visually checked it by turning carb upside down when i had it apart and it looked level. any ideas are appreciated. 
       
      Thanks.
      Todd
    • By HHurks
      Hi to all
      Newbie here. Not new to ATVs. Look forward to learning a few new things and hope to maybe help some too.
×
×
  • Create New...