Quantcast
Jump to content


TRX 400 ex dies when hot...


KrazyRdR83

Recommended Posts

I want to thanks those in advance that help me out with this.

Lately I've been having some running issues with this thing. When I first start it up, runs fine with no issues. I'll ride it for up to 5 minutes, and when nice and hot, idle begins to drop and eventually cuts off.

Carb has been taken off a few times now to make sure things are clean, filter was cleaned, valves were adj as they were a little loose (when adj it actually took a bit longer to die). For some reason I can't get to the sparkplug...? What else, oh, petcock was replaced, and made sure fresh has was used. When I try to restart it will only start if I give it gas, and when I try to let it idle, it idles really low then cuts off.

But once I let it cool down long enough, it will start up (off the choke) every time and idle, take it for another ride, and when up to operating temps or higher issue comes back.

Juan

Link to comment
Share on other sites

I am thinking you have an ignition problem, some ignition components will start to fail when they get warm. Ride it until it dies then pull the plug wire off and check for spark. If there is none, start checking ignition parts, coil, CDI, stator, pickup, plug wire, and all wires and switches in the ignition circuit.

Link to comment
Share on other sites

It's an 05...but got it figured out.

Here's what was going on, after checking things over and over again. Got it running and hot, put the air box back on, and as I went to put the crankcase vent on, it would start to die. Once removed the idle would pick back up. So this whole time, once the motor got up to temp, the crankcase vent hose would pull air away from the carb...

Link to comment
Share on other sites

I'm sorry, I did not mean the air cleaner, there is a second blow by tube on the valvle cover, it may have a filter on it, or it may run into the airbox. Either way, make sure nothing is obstructing it. Also, the lower tube that comes out of the crankcase is connected to a catch tank that attatches to the intake tube, make sure that tank is not clogged either.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Brantley11
      Hey everybody,
       
      My proficiency is with Hondas and Yamahas make me see RED!
       
      This bike is my brother in law's, it has 1199 miles on it and went from running great to dead with no start. Every once and a while it will start and sputter for 2 seconds. It is extremely sporadic when it fires but never runs for longer than 3 seconds. 
       
      Here is where we sit:
      Brand New Fully Charged battery
      Carb was cleaned with air hose and carb cleaner then into the ultrasonic cleaner with Aircraft aluminum cleaner
      New Shindy Carb kit (made in Japan version)
      Cleaned out petcock and gas tank
      New 93 Non Ethanol Gas
      New Spark Plug
       
      It gets a spark through the spark test light every time
      Bluish white spark
      When holding the spark plug 1/4" - 3/8" away from head it will jump and spark to the head
      Good Compression
       
      Here are the readings:
       
      Pickup Coil 519 Ohms (range 459-561)
      Charging Coil 266 Ohms (range 270-330)
      Lighting Coil 0.700 (range 0.702-0.858)
      Spark plug Cap 10.58 Ohms (10kohms
      Ignition Coil Primary Coil 0.5 ohms (range 0.18-0.28 ohms)
      Ignition Coil Secondary Coil 8.20 kOhms (range 6.32-9.48 kOhms)
       
      Would y'all think stator and pick up coil, rectifier or CDI are the culprit?
       
    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next
    • By 1998Zuki250
      Anyone here ever have any issues with the law for riding on public land? Im in upstate NY and they seem to ruin everything so Im over cautious. 
    • By N00bie
      From Arkansas. Just bought a 2012 Gator 850i RSX because I could not pass up the price. BUT it has an idle problem. So, to be honest, I joined just to get a service manual. I have a choice: 1)Buy a hard copy: ~$100; 2)Buy a CD ~$35.00; Get a direct download for free posting 10 times; or get a download for $29.00 (subscription). Haven't decided what to do yet.
    • By John Sinclair
      I WANTED TO UPGRADE THE CARBURATOR ON MY 1992 BIG BEAR 350, SO I ORDERED A NEW CARB FROM EBAY.  ACCORDING TO THE WRITE-UP IT WAS A GOOD FIT FOR BIG BEARS FROM 1988 TO 1996.  WHEN I REMOVED MY ORIGINAL CARB I NOTICED THAT IT WAS DIFFERENT FROM THE NEW CARB MY CARB HAD TWO THROTTLE  CABLES THE NEW CARB ONLY HAD ONE CABLE.  HOW CAN I MAKE THIS CARB WORK ON MY TWO CABLE THROTTLE?  
×
×
  • Create New...