07 kingquad 450 4x4 button issue

[nonstuck]

Hi,

New to the site, and atv's, but have been riding on 2 wheels forever.

I just purchased an 07 king 450, and didn't notice til I got it home

that 4 wheel is displayed on the gauge all the time. This is regardless

of the position for the push button 4 wd. I haven't had the opportunity

to put it up on blocks to confirm all 4 are turning. Is there a fuse

or something that is causing the display to be constant ?

This rookie is open to any and all advice.

Thank you in advance.

[Sc0tt]

I merged your threads into the Suzuki forum. I believe you will get your best answers from here.

[DirtDemon]

There is probably a sensor that triggers that light, said sensor could be faulty. I would do just like you were saying, get it up in the air to see if everything else is working as it should.

[nonstuck]

Thanks Demon,

Yes, I did confirm last p.m. that front 2 are not turning. Guess I'll start

with some basics, check voltage and etc. Just thought perhaps someone

had experienced the same problem, and had a likely suggestion.

Thanks again !

[DirtDemon]

So then it would be logical to assume that there is a gearshift position sensor that is stuck on even though it is only supposed to be activated when the machine is shifted into 4wd. There is a gearshift position sensor located on the outside of the engine case, I am not 100% sure, but I think it would be on the left hand side as you are sitting on the machine, but check both sides as I am not sure. It is a small plastic thing with two screws holding it in and wires coming out of it. There is a small pin that allows the gear shift shaft to turn the switch portion of the gear position sensor. I would suspect that either there is a problem that is not allowing the switch to be turned, or the sensor/switch itself is just bad. This same switch should probably activate a Reverse light, does the reverse light work properly? Good luck.

[yimcyco]

front diff actator bad

Ive replace 2 in a week already