Quantcast
Jump to content

Recommended Posts

Posted

i have a 95 polaris xplorer 400. just replaced the throttle cable. has oil inject cable as well. whats the procedure for adjusting the cable. start at the carb and adjust till the carb is wide open or start at the throttle adjuster on the bars. it seems to run ok and starts fine but now as soon as i hit the throttle hard it bogs and then catches up. im unsure of procedure.

Posted
i have a 95 polaris xplorer 400. just replaced the throttle cable. has oil inject cable as well. whats the procedure for adjusting the cable. start at the carb and adjust till the carb is wide open or start at the throttle adjuster on the bars. it seems to run ok and starts fine but now as soon as i hit the throttle hard it bogs and then catches up. im unsure of procedure.

That sounds more like a jettin issue !! IMO

Posted

the reason it does that is because the quad is idling to low. loosen off the cable on the handlebars, then adjust the idle screw on the carb until it has a smooth idle and does not bog when you hit the throttle. Then adjust the one on the handlebars until most of the slack except for approx an 1/8th of an in of movment in and out is obtained. then try it. from there it is just fine tuning so the quad doesn't idle up when you turn sharp left or right. good luck.

Your friendly neighbourhood mechanic.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Popular Now

  • Similar Forum Topics

    • By realpilot
      I am unable to find a wiring diagram for this UTV.  When I turn the switch to on, the contractor does not engage.  The Brake pressure switch and the parking brake switches work correctly. What else should I be looking for?  All of the diagrams I have found are for newer models and the wire color coding is different.
       
      Thanks
    • By Elk
      2002 Polaris Magnum 325
      How to replace throttle assembly spring?
    • By LashinWheeler
      Hello all, I have a 2006 Polaris Sawtooth with no spark. It has a dead battery but with a jump pack on it, it will still not Spark. Plug is good, Throttle ETC is not closed, Stator pick up coil seems to Ohm out in the correct range, Unsure how to properly check the CDI. And when ignition is on the Neutral and reverse light come on but after cranking just the neutral stays on. 
       
      Any help would be great,
       
      Thanks!
    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By rjsummer
      Just picked up an 84 LT185 ATV, I understand there was an accessory add  on that gave it electric start, anyone have any info about that kit? 
×
×
  • Create New...