Quantcast
Jump to content

Recommended Posts

Posted (edited)

Having trouble with a bayou 94 Kawasaki 300 that's been sat up for a year. Installed the honda carberator cleaned tank put new gas . After all of this it ran with a rough idle but it did run I ran it for about 45 minutes. Next day it will not start any suggestions?

Edited by Jpvip1
Fourgot items
Posted

Hi, you were correct, I installed a new plug and it fired up and now it does run. My next problem is the idle, it has a rough idle it is up and down, I tried adjusting the air screw both in and out and it increases and decreases the idle a little but it is not a smooth run it still goes up and down, it's just a rough idle. Ivan ride it and it runs if ebut when I stop the idle goes back rough running, after idling a few mi utes I have to use the throttle to keep it running it wants to stop. Any suggestions

Posted

there is an air/fuel mix screw, mine is on or near the underneath of the carb, and an idle screw, usually quite big with a spring. alot of people will think it's either or a mix/fuel or idle screw, i know i did until i talked to cheriah here. that is all i can think of, usually the idle screw is suggested to be turned in all the way tight, then 1 1/2 to 2 1/2 turns out, then you adjust the fuel/air mix screw ....

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
    • By marlon smith
      1990 kawasaki bayou 300c idles fine but pops out exhaust and intake when trying to excel, will not take throttle past 1/4 , any one had this problem?
      have replaced carb twice, same thing, fresh built engine cylinder head, same as before, new spark plug, flywheel key is good, pulser test good, good spark
    • By gordonmacritchie
      on my honda trx 500 we have no power to the ignition switch for starting or ignition
      we have lights and horn working
      all fuses are fine
      have traced through the harness and cant find any broken wires or bad connections
      from what we have gathered so far the pgm fi unit is not sending any power to the fuel pump relay to power everything up.
      if we put power direct to the ignition switch plug then everything works but wth the key in the off position.
      does this sound like a faulty pgm fi unit?
    • By Admin
      View File 1986-1989 Honda TRX350 Fourtrax TRX350D Foreman service manual
      1986-1989 Honda TRX350 Fourtrax TRX350D Foreman service manual
      Submitter Admin Submitted 03/08/2026 Category Honda ATV  
    • By toe420
      Hey everyone, I just picked up a 91 trx350 4x4 with a blown top end. I don't know what happened to the poor thing but the cam journals that were round are oval shaped now. I also bought a running engine from a 92 trx350 4x4 to swap into the 91. Is there anything in particular I should be checking while the engine is out and I have good access to it and the frame? 
×
×
  • Create New...