Quantcast
Jump to content

Recommended Posts

Posted

Hi guys,

I dont post here much but I figured I would pass on some info in the hopes it will help someone.

I was having a problem with my KQ while plowing snow the other day. It would stall frequently while idling. Especially when stopping to switch to reverse or a forward gear. But it would run fine at anything above idle. My buddy came over to help me with it.

We determined that it was starving for fuel or dirt was stuck in the carb somewhere. After confirming that there were no clogged screens, filters or vacuum leaks anywhere, we disassembled the carb and blew out all the passages with carb cleaner and compressed air even though everything looked spotless.

Then we checked the pilot screw setting. Someone had already been in there as the plug was removed. We checked the setting and it was 2-1/2 turns out from the seat. We set it at an even 3 turns and put it all back together.

It now runs flawlessly with no stalling! I believe it was just a bit lean on the low end.

Anyway, hope this helps someone.:cheers2c:

BTW, this is my first season with this (or any) quad and I am AMAZED at its plowing ability for such a small machine!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By ButchM
      Hisun 700 EFI. Replaced TMAP sensor had broken off . Fuel pump pressure 41psi. The only way I can keep it running (and runs fine) is to close off fuel return line. 
    • By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 
    • By BuckBilly
      Just thought I would start a poll on this topic manly because I'm not a fan of belt drives. Just want to know which you prefer.
    • By Louznmemind
      I know this is a stupid question but here I am.. I'm wanting to have the ability to disable my taillight/brake light on my '96 Polaris Xpress at will, it comes on with the key and there are times I don't want it to illuminate. I have basic wiring knowledge and I'd like to put a toggle switch to disable it. I'm not sure of the wiring setup on this thing, can I just use a toggle switch on the ground wire to kill it when I choose? Can someone clarify which wire I need to work with and the easiest way? Excuse my ignorance yall.
×
×
  • Create New...