Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

AJsLTZ400

2006 Suzuki LTZ400 - Hard Start~Cranks But Won't Run

Recommended Posts

I have a 2006 Suzuki ltz400. i bought it off some kid upstate and it ran when i tested it at his house. i brought it back to Long Island then it wouldnt start. it doesnt electric start to be more specific. Itll start if i pop the clutch in first gear but it doesnt idle, it dies. only does this when the motor is cold, when the motor is warmed up, itll idle. so i took it apart the i found that it had a blown headgasket. i replaced that and now it still doesnt start. i checked the timimg and its TDC on the bottom and top. now it cranks very strong and the compression is strong but it still wont turn over. its popped a couple times but it doesnt run. i cant seem to figure it out, i need help please.:mad::mad:

Share this post


Link to post
Share on other sites


is the spark strong? have you tried a new plug? don't replace with the plug that's in it, it might be wrong. make sure it is right one for the bike. ngk has a good chart for atv's ...

Share this post


Link to post
Share on other sites
is the spark strong? have you tried a new plug? don't replace with the plug that's in it, it might be wrong. make sure it is right one for the bike. ngk has a good chart for atv's ...

yeah i got the manufactor recommanded spark plug. it does have spark.

Share this post


Link to post
Share on other sites

do you think it's a fuel problem? motor needs fuel, air and spark ... if it's getting good fuel supply, the carb might be somewhat dirty. seafoam is a good fuel additive and it'll save you tearing the carb apart ...

Share this post


Link to post
Share on other sites

I dont like to use it but does it run on starting fluid? If it does then its fuel. If not then its spark or mechanical

Sent from my SGH-T989 using Xparent BlueTapatalk 2

Share this post


Link to post
Share on other sites


do you think it's a fuel problem? motor needs fuel, air and spark ... if it's getting good fuel supply, the carb might be somewhat dirty. seafoam is a good fuel additive and it'll save you tearing the carb apart ...

it seems to be getting fuel, air and spark. the carb was also cleaned out. rejetted and carb cleaner.

Share this post


Link to post
Share on other sites

What are the compression #s... If at a total loss and willing to have it repaired bring it to Diggin Racing in Bohemia. Chris did excellent work to my motor. Highly recommended

Sent from my SGH-T989 using Xparent BlueTapatalk 2

Share this post


Link to post
Share on other sites

Agreed..... When you checked timing did you verify the cam marks or just the crank? Also a real

biggie is did you adjust your valves. Unadjusted valves make for a hard start.

Share this post


Link to post
Share on other sites


Hey guys thanks for all the help, it was the valves. The intake valve lash was at 0. I didn't realize how important the adjustment was the valves. I'll give you guys an update when it fix it. I'm waiting on parts now:wink:

Share this post


Link to post
Share on other sites

My intake valve was really tight. 0 valve lash clearance. I think that's the problem, I'm waiting on the DRZe kit and Ferrera valves then I will replace the old parts. Thanks for the help guys ill give you an update soon

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Tagged Content

    • By Ironfist104
      My wolverine has a new carb kit, new battery cranks over and over take it to the point of killing the battery to start sometime.... but it I give a tug on the start rope while I'm cranking it with the starter it fires right up.... any advice?
    • By izzydum1
      Any ideas on what would make a coil not fire? She was running fine, then began slow start. Now wont start at all.
    • By Suzuki24
      I have an 04 ltz and it started sputtering a little bit while going down the road and I was low on gas so I just figured that's what it was. But now I can't get it to start I completely cleaned the carberator put a new spark plug and coil pack in it and all it does is turn over. It has compression it's getting fuel and it is sparking but all it does is turn over any idea what it is??
    • By jerrymcoo1
      If you keep the starter button down it will run alittle let off the starter and it dies ? HELP
    • By RichUncleSkeleton
      Hello
      Just signed up, as I've had a recurring problem, and need some help.
      To start the bike I have to put the choke on all the way and 4 squeezes on the gas, Then as I push the start, I slow squeeze the throttle about half way for it to catch....If I miss it, then it will take 5 mins of slowly finding the sweetspot on the choke in unison with some throttle squeezes.
      Then I have to to hold the throttle to keep the bike going, using the choke will stall it out. after about 3 mins of holding the throttle, I then can let it go, and it idles fine, and runs fine. If it sits for a few hours it's only slightly hard to start, but a few days of sitting, and it's a lot more work.
      Had the bike serviced they couldn't figure it out. They swapped peticock, plug, new gas, all new lines, new throttle, and cable. Said the carb was fine, and clean. New air filter, said fuel pump was fine, no leaks around carb boots, new battery, new rectifier.
      Ran some sea foam through it....Runs Great.....Just such a pain to start...
      Thanks
  • Similar Topics

    • By Abbeypalm
      While cruising, my 2011 750 king quad suddenly shut down. As it happened, red lights on the display flashed. Any ideas? My head lights suddenly stopped working about a week ago, if that helps. I have no power at all. Thanks 
    • By Brennon Heflin
      So I bought a 2000 quad runner 250. I'm having some issues an wondering what it could be I replaced the pet cock valve an the fuel filter an pump inside tank I also put a voltage regulator on it. The problem I'm having is that when u give it half or more throttle it bogs down an loses power what could it be the bike is almost like new an cant figure it out any help would be great
    • By Stephanie Webb
      I have a 2000 500 quadmaster lta an just rebuild the gear box an my high gear is like nuetral will not move but all other gears move nothing looks broke just need some help cant figure out what gear that would be or if it could be the shifter fork 
    • By NoahJakavi
      Hello i have a linhai 300 of the 2004+- era. I had a cluch problem so we changed it. After changing it has a hard time to start going. When you pop it into gear and press the gas it barely drives but when it starts going about 20km/h it start driving well the acceleration is normal and everything do you have any idea of what could be the problem
    • By smitht18
      Looking for the rectifier.  Most bikes have near magneto.  It appears the KQ has it in front.
      Can someone tell me exactly where it is? 
      Bike not charging and magneto checks out ok
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...