Quantcast
Jump to content

2000 Suzuki King Quad 300 4X4 Runs Out of Fuel

gtyfisher

By gtyfisher
in Suzuki ATV Forum

 Share

Recommended Posts

gtyfisher Newbie

gtyfisher

Posted
Posted

My 2000 Suzuki quad king 300 4X4 starts great and runs great but after I drive it for a while it won't take it's gas and it won't move. If you turn it off it will start and idle fine til you give it the gas and it won't take it's gas again. You can turn it off and it will run fine again but it won't take it's gas again. This will go on for sereral restarts and finally it will run fine again, but after awhile of driving it will start this process all over again.Does anyone have any suggestions what it is

  • 2 months later...
dtbprc Enthusiast

dtbprc

Posted
Posted

check fuel line, petcock and also gas cap and line out of it. if clogged you get vapor lock after a few minutes. not enough gas gets sucked into carb/engine then.

  • 4 months later...
  • 2 weeks later...
thariggs Newbie

thariggs

Posted
Posted
My 2000 Suzuki quad king 300 4X4 starts great and runs great but after I drive it for a while it won't take it's gas and it won't move. If you turn it off it will start and idle fine til you give it the gas and it won't take it's gas again. You can turn it off and it will run fine again but it won't take it's gas again. This will go on for sereral restarts and finally it will run fine again, but after awhile of driving it will start this process all over again.Does anyone have any suggestions what it is
Safety fuel petcock is the main fault vacuum operated fuel shut off bad fuel mixed with ethanol stuck choke cable my main was vacuum petcock will allow fuel into carb. long enough to starts backfire run out of fuel even tank full dealers charge anywere $112 part plus labor best is go online bangood.com 01 raptor fuel petcock $6.99 its two screws and a vacuum plug on carb problem solved also stay away from fuel with ethanol it sits week or two gums up your whole fuel system.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Popular Now

  • Similar Forum Topics

    • realpilot
      1999 Ranger 6x6 no start
      By realpilot
      I am unable to find a wiring diagram for this UTV.  When I turn the switch to on, the contractor does not engage.  The Brake pressure switch and the parking brake switches work correctly. What else should I be looking for?  All of the diagrams I have found are for newer models and the wire color coding is different.
       
      Thanks
    • jay41198
      1988,suzuki quadrunne LT 4wd cdi box work around
      By jay41198
      I am missing a cdi box for my 1988 Suzuki quadrunner LT 4WD is there a rplacement box that i can wire into this bike to get it back running beings that the cdi box is no longer made 
    • OldATVowner
      99 Bear tracker no neutral or reverse light or start button
      By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • Shorty51
      2006 Arctic Cat Utility transmission drive shaft replacement.
      By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • LMI
      2005 Suzuki King Quad Battery Question
      By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...