Quantcast
Jump to content


2005 Polaris Sportsman problem starting


Russs

Recommended Posts

  • Ajmboy changed the title to 2005 Polaris Sportsman problem starting

Sounds like the Carburetor...  If it it is starting with Starter fluid that means you have Ignition and spark. It's probably not getting gas from the carburetor. It might need to be rebuilt. Did you have a fuel filter between the gas tank and Carb?

Link to comment
Share on other sites

I’m not sure.  What would it look like.  There is a white tube that is connected to a hose going to the carburetor.  Any thoughts other than that.  Also you say I would need to rebuild the carburetor.  What would that install?

Link to comment
Share on other sites

A fuel filter goes after the gas tank but before the carburetor to clean the fuel of any debris that might make its way into the carburetor and clog the jets. Here is a generic picture of one. To rebuild a carburetor you have to take it completely apart and clean and soak the parts. You buy a rebuild kit that contains gaskets and parts that usually wear out. If you are not comfortable with rebuilding the carburetor you can buy new ones pretty cheap. Around $50.

Fuel_Filter_-_Plastic_150cc_to_400cc_ATV_300cc_2x4_4x4_and_4x4_IRS_1.jpg

Link to comment
Share on other sites

Normally you replace the filter if it has one. Or you put one in to protect the carburetor if it does not have one.. Factory parts are always best.. If you clean you carburetor very well and rebuild it , it should work like new.  I myself have used aftermarket replacement carburetors that sell for around $50 on Ebay with no problems. Find a seller with positive reviews. I only use them if the factory carburetor is beyond repair or missing.

Link to comment
Share on other sites

If it has a choke use it for a few seconds and then open the choke and it should start. It does not take much for the carburetor bowl to fill and be ready. I would still open the carburetor first and rinse it out.. lots of times the debris falls out while cleaning. If you are careful and don't ruin the gaskets you can possibly get away without a rebuild kit. I would do that for peace of mind. If it even just runs a little better after cleaning it you know for sure it is a carburetor problem before you spend the money on a new caburetor..

Link to comment
Share on other sites

So I took the carburetor out as much as I could.  Not sure how to disconnect the throttle line and one other line going in.  Did discover that the rubber intake was worn and is more than likely the problem.  I pushed the carb. into it the best I could and it started right up and even idled for a bit.  I have ordered some parts and a manual.  I will be back at it next week when they arrive.  I really appreciated the help.  Hope to be up an running very soon.  

Link to comment
Share on other sites

  • 4 weeks later...

Ok, Put everything in, changed all the fluids, Plug, and it starts up and runs.  Did adjust the the idle and for the most part runs good.  There are two issues Im still having and would love your thoughts.  

1- I start it every day and let it run for about 5 min.  Some days it starts right up and others I have to pull the chock out and restart.  So inconstant starting, which makes me nervous being on the trail and having an issue.  

2- When running in low and high some times skips or misses.  When running in revers, misses alot to the point you have to stop and let the idle catch back up.  

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By jashadams
      So I installed a new shock on my 125 yesterday sadly it wasn't adjusted right I took it off to adjust it tried to install it again today and it no longer fits I loosened the nuts on the spring again and it still won't fit idk what I'm doing wrong when I try to install it but I'm lost any tips or videos would be great thanks.
    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next
    • By Johnfj44
      The stock driver seat cushion is separated at a seam. I took the seat apart and found that the material has torn and cannot be re-stiched. I'm trying to find a replacement seat. Any suggestions? Hoping for a used seat but couldn't find one on Ebay.
    • By Slitzer
      Hi,
      Got a Big Boss produced 2016 YM 2017 that gives DTC 520 285 2 (random)
      What I understand is correlation code for brakesensors, very little information in workshop manual.
      Removed front plastic to discover that no connector was mounted on the brake pressure switch!?
      The only "brake" information seems to come from the micro switch at the brake lever.
      Does anyone know if Polaris does anything special on the 6x6 or had this issue?
    • By bighoss
      i got my son new outlaw 50 a few weeks ago and we went rideing yesterday and while we were riding it died and it took me like 10 min to get started back and it died agen when we got close to truck so i pulled it back took the plug out it looked like it was drop in a bucket of gas took the air filter out and the ait box was full of gas also got home it started rite up today i started it it starter up but was blowing what look like water out of the exholst let it idel for a lil bit did not die but as soon as hit the gas and let off it will die what does that sound like i thnk i going to take it back to dealer and tell them to fix it as it is under warrenty but would like to know what it could be first
×
×
  • Create New...