Hello new member here. I joined the site looking for a service and repair manual for my 2004 Bombardier Outlander 330. Unfortunately it sat outside without being ridden for a number of years and I would like to restore it if possible. Any advice welcome.
thanks
Matt
Background,
This winter (Dec.) I was plowing and everything just died, just quit. No lights, no pull start, No nothing. I've had this problem before and I changed the voltage reg and it ran fine for over a year. Then this. So I changed it again, thinking this was the same problem. Tried to start it and a small pin hole in the CDI appeared with electrical smoke.
Months go by and I finally decide to just replace parts (I'm Horrible at electrical issues). I changed the stator, new CDI, new Voltage reg, new starter solenoid, tested the starter (prefect), charged the battery.
Went to start it and the solenoid rapidly clicked. All the dash lights on, headlights work. Pull stared it and it fired right up no issues. Looked into the rapidly clicking starter solenoid and it was not enough juice in the battery. Took the battery completely out and hooked up a jump box to it turned the key, light on, everything looks good. Pushed the starter button and it fired right up ran great. Turned it off to test it again, Turned the key and nothing. No dash lights nothing. Took the jump box off and pulled started it. Started it right up. Re-hooked the jump box, still nothing.
Any Ideas?
on my honda trx 500 we have no power to the ignition switch for starting or ignition
we have lights and horn working
all fuses are fine
have traced through the harness and cant find any broken wires or bad connections
from what we have gathered so far the pgm fi unit is not sending any power to the fuel pump relay to power everything up.
if we put power direct to the ignition switch plug then everything works but wth the key in the off position.
does this sound like a faulty pgm fi unit?
Recommended Posts