Quantcast
Jump to content

Recommended Posts

Posted

Hi guys, trying to get a quad running again. It was running fine but the electric start did not work. My uncle was using it and the pull start snapped. So I replaced the pull start and electric starter motor. Now it just cranks and cranks but will not start. I have spark, I have fuel to the carb, I know this is a 2 stroke with a separate oil tank, what else should i check?

Posted

Fuel to the carburetor does not mean fuel to the engine.  I would spray starting fluid into the air intake during the cranking and see if it fires.  If so then the carburetor has a blockage on the main fuel intake at the bowl/float. 

  • 2 weeks later...
  • 3 weeks later...
  • 4 weeks later...
Posted

I was trying with starter fluid straight into the intake, no good, once I finish the other 2 quads i'm working on and free up space in my garage ill bring that one home and dive into it deeper

I'm praying its not compression

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Forum Topics

    • By ruslan1o1
      Hey everyone looking for a suggestion of where i can start looking. But first I'd like to explain what happened. Took the bike this morning got it started in 6 degrees celsius in 6-7 kicks? No choke. Drove 6km and when shifted to next gear bike decided to just shut off, stopped checked everything out seemed good, started first kick and on i went, drove maybe another 2km bike did same thing but this time it took me 10-15 kicks to get it started, on the third time after a kilometer decided not to start at all. Kicked it like a 450 a couple hundred times, nothing. So far checked gas is good, bypassed fuel filter and on/off valve to eliminate that problem, hot wired the kill switch in case something got corroded there. Nothing. Any suggestions would be welcomed. (Heard valve adjustment are a must do?)
    • By Daleon
      Do not know what else I need to attach the pull start to this machine. I have the pulley but nothing to attach it with. Could you help with what else I need. It's a 1999 Lakota 300
    • By Gwbarm
      I finally got around to working on the TRX, this has been an ongoing problem with this machine. This is a machine that we keep on my Fathers property, i dont see it that often, my brother haad it professionally repaired last year and year before same problem, the new starter gears and bypass gears last about a year and the machine is not used that often, he said he was done with it , so i thought i should go take a look. Sure enough the gears were all malled again. 
       

       

      IMG_4910.mov   There is some slack in there but most is taken up by the gear cover,if anyone with history with these machines has had the same problem, let me know your findings. Where i am now im looking for finding replacement honda gears on Ebay and try those. I suspect the original was replaced with aftermarket gears years ago and they just worse quality as the years go by. 
    • By Andyjack
      Hi quad is up and running now, starts fine, revs and ticks over fine but when riding its bogging a bit. If your sat with engine running its fine but when you set off your having to rev it very slowly to go otherwise it drops its revs. And i mean very slowly, try rev normally and revs just drop off then when your going its bogging slightly. I have tried adjusting air screw but doesn't seem to make a difference. Any ideas. Seems like an air problem but not sure.
    • By ankhearty
      New member here hoping to get help on procedure to remove old non-working starter and install new one.
      John in San Antonio
       
×
×
  • Create New...