Quantcast
Jump to content


2012 ac fuel pump


Kris Weix

Recommended Posts

Ok well as long as you have dash lights. It’s something holding the start circuit out. Is the bike in neutral and start checking all the safeties as well as the starter circuit.  Put a voltage tester on the battery and hit the start button.  If the voltage drops the starter may be jammed or bad.  You can also put a tester on the starter wire and see if the starter get voltage when you press the start button.  Do you hear any clicks coming from the starter relay under the seat ? Or any place else on the bike when you press the starter? 

Link to comment
Share on other sites

Check the kill switch, left handlebar, red switch,  that would prevent the fuel pump from pressurizing.

Check ignition fuse (IGN on the fuse block) it could have popped and you would still have dash and headlights, but the pump won't pressurize.

On these machines, the start circuit would only prevent the starter from engaging, the fuel pump will still pressurize. Arctic cat machines allow you to start the machine in gear only if the brake is engaged. There is a relay called "start in gear" but I don't think this is his problem.  It is either the kill switch or something in the IGN circuit.

Since this is an EFI machine, battery condition is very important, battery may appear to be OK, but only a load test could verify that.

 

Mike

 

Edited by mikeexplorer
  • Like 1
Link to comment
Share on other sites

  • 5 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Gwbarm
      I generally use Non Ethynol fuel in all my small engines. I just got back from the gas station and that fuel has really increased in price since last year, I will continue to use it, even though its north of 1.00 a gallon more. That seems minor compared to cleaning and repairing carbs every year. 
      I was just curious as to what others are doing in regard to gas in their quads, i know a lot of the newer ones are fuel injected which shouldnt pose a problem, but i have had lots of problems with rust and jell forming in carbs when using ethynol fuel.
    • By BuckBilly
      Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
      Let's see if we can make this a daily event.
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
×
×
  • Create New...