Quantcast
Jump to content


2006 Sportsman X2 500EFI electric problem


gregorio

Recommended Posts

Like the title says, my quad is suffering from a short.  I think I traced it to a 4 wire harness that enters the engine case above the manual starter just in front of the electric starter.  It is rather odd in that it has 3 yellow wires and one gray or tan wire.  If I giggle it, I lose all power to the quad.  Is this the magneto underneath? 

Thanks in advance,

Greg

Link to comment
Share on other sites

That would most likely be the wires going to your stator coil.  I’m only guessing without looking at your diagram  but there are very few wires that come form inside the engine.  The stator coil, the pick up coil and maybe a neutral safety switch.   If your moving the wires around and they kill the engine my guess would be they’re shorting  out right at the entry fitting where the wires enter the engine.  It’s a plastic collar that’s fitted for the engine case cover.  Post a picture of where the wires are coming from.  

Link to comment
Share on other sites

11 hours ago, gregorio said:

Like the title says, my quad is suffering from a short.  I think I traced it to a 4 wire harness that enters the engine case above the manual starter just in front of the electric starter.  It is rather odd in that it has 3 yellow wires and one gray or tan wire.  If I giggle it, I lose all power to the quad.  Is this the magneto underneath? 

Thanks in advance,

Greg

Those are the wires for the charging system or stator, behind the flywheel.  On the EFI Sportsman's, if the ECM/computer isn't getting a signal from the stator, it won't run.

Sounds like one of the yellow wires has a break.  The tan wire is a ground wire.  Polaris wiring is bad about breaking inside the insulation so finding which wire is broke is a little tricky.  If you can check each yellow wire for continuity while someone jiggles the wires, you may be able to find it.  The alternative is buying a whole new stator.

Link to comment
Share on other sites

Well, before I tear it apart, I am going to read through the service manual to get an idea how difficult this might be.  It looks like I might have to remove the manual starter.  If it anything like other manual start engines, I'm in for a real cussfest.

Thanks for the advice.  BTW, the "alternator" was repaired/replaced about 2 years ago by the dealer.  I can't find the paperwork but it was not charging and killed the battery.  So, new battery, "alternator" a wire harness that was shorted and general service put me back on the road for the low low price of $1800!  Not going there again!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next
    • By STLJ
      Gday all,
       
      Been trying a couple different ways now to download a manual. Not sure what I am doing wrong but could someone walk me thru it?
      I go to DL page and click on link
      get a pop up for a PDfixer or something
      close that and then hit download button and no go
      tells me I have reached my limit but I have never DL anything ever. 
    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
    • By jatho
      Has anyone else had an issue on older king quads where the oil would leak from the top of the head (due to a failed gasket) and drip onto the hot exhaust? Mine got so hot one time it caught fire. Just wondering if this is a common issue, as I've seen the same thing happen on multiple bikes that were the same model. 
    • By mkibbe
      My 2014 750 king quad stalls sometimes when I touch or turn the handlebars,the problem has gotten worse,my machine has 475 miles and is only trail ridden,I have a new factory battery and i have 14.2 volts when the quad is running and 13.3 on the battery when not running,also using a multimeter there is no change in volts when turning the bars until it does stall,If I pull the 40 amp power steering fuse it will not stall.......I've been told its the ECU,Hate to buy one if thats not the problem,but its kinda leaning towards that,,,,,need some opinions.

×
×
  • Create New...