2000 Yamaha 350 Warrior Not Getting Spark

[Josh Boyd]

I have replaced the cdi box,spark plug,coil and stator but still no spark.

[Ajmboy]

Is it possible that its a bad plug? Are you pulling the plug to check for spark?

[MarkinAR]

Assuming the CDI you replaced with is a chinese cheap one?  i'd put the OEM back in then continue testing.  Check the plug wire and plug boot also with a connectivity setting on a multimeter.  I've seen boots go bad.

[Josh Boyd]

It's a new e3 diamond fire spark plug and yes I pull the plug out when I check.im not getting power on my orange wire either.

I got the cdi box off of Amazon the company is called caltric

[MarkinAR]

Caltric CDI is probably one of the better chinese junk CDIs. For what it's worth, NGK will do a lot better in a jap motor than e3. What is the orange wire? I'm not familiar with that harness. Where does it go?

[Josh Boyd]

I finally got power to my killswitch but no spark is coming from the coil

[Adrian Lyttle]

You find that the regulator power is greater now you have dun it be burning out your cdi uite you need to down the power source 

Need new cdi again and check the regulator be for you put in cdi 

Edited May 10, 2020 by Adrian Lyttle
Need bit more in it said

[Josh Boyd]

I'm just not geting to the coil now I can do it by hand but that's it

[MarkinAR]

Not sure I understand what you just tried to say. 

[Josh Boyd]

I'm just not getting spark to my coil.i can run a hot wire to it and it will spark but that's it