Quantcast
Jump to content

Recommended Posts

Posted

I have a 97 Suzuki kingquad an a new carb an yet still flooding an sounds like it wants to start but won't. Flooding so much that while cranking over gas is actually spraying out the back of the carb.  I'm thinking maybe need new fuel pump an check my vaulves an timing. Also don't know how many p.s.i. the fuel pump is an can I switch over to an electric on????

  • Admin changed the title to Need help!!! 1997 Suzuki King Quad No Start
Posted

If that's a new carb, it shouldn't be doing that. Sounds like a carb float or jet issue. Electric fuel pumps are for fuel injection, you should have a mechanical fuel pump. Gas spraying out the carb sounds like its under pressure. 

If you have a 300, here's a good video illustrating a mechanical fuel pump and delivery.

 

Posted

It is possible that the fuel pump is at fault but not that likely. They only make a couple PSI which assists in bringing gas uphill to the carb when the fuel is low in the tank. When they fail it usually results in a lack of fuel, not too much.

What I suggest you try is a simple test: remove the original fuel line at the carb & get a clear hose of the same size. Connect the hose to the carb and fill it with gas. You need to support it vertically and watch the level in that clear hose.

If it drops and cannot hold that level, the problem is with the carb - float valve or float itself is bad. Sometimes it takes quite a while for the level to drop but be patient, I've seen many carbs fail this test! Worth a try and it's cheap!!

Posted

Spock58 is correct. Pulse fuel pumps aren't capable of producing too mush pressure. You most likely have some debris between the float needle and seat is the carb. or the float needle is out of place, or the float or needle are sticking or stuck for some reason. A quick inspection  and cleaning will probably solve the problem. You can retest it like Spock58 says before reinstalling it as well to see if you have the problem resolved. make sure the float bowl gets completely full and fuel and the tube is staying full also. A small auxillary fuel tank might be helpful here as well.

Posted

Check the vacuum hoses going to the fuel tap and the fuel pump, they might be sucking fuel down them and into the engine. They could also be leaking all the time and fill your sump with fuel. Check the oil level and smell looking for fuel.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By kevinohio
      Does anyone have a copie of the owners/operators manual.the basic book that comes with the atv.i need the smaller one.i have the great big repair manual one.
    • By buriedpast
      As the title says, I've got a crankcase full of fuel / oil to deal with and figure I'll just start from the top and move through the system.  Going to start with a rebuild of the petcock and then the carb if the problem isn't fixed with the petcock rebuild.  I figure I'll go with a Moose kit unless others with experience recommend another brand (All Balls, etc.)
      Any suggestions?  Thanks in advance.
    • By rjsummer
      Just picked up an 84 LT185 ATV, I understand there was an accessory add  on that gave it electric start, anyone have any info about that kit? 
    • By Rockbottom
      2008 400 big bear was running now will not start
      have power to relay, in neutral, press start have power to starter but nothing happens starter does not turn
      i have good ground at battery to frame and added ground from wire harness to frame beside batter/ frame ground
      blue white wire to cdi has power with key on
      I believe the neutral lock out is working since is was before i shut it down
      if i put  it in gear and hit the start button with key on the relay does not click or send power the starter
      The 3 wires at the relay have power with key on
      What should i test next?
      thanks ahead
    • By Mister907
      Hi guys, I have a 2004 big bear 400. Last winter while plowing the driveway, I heard a loud pop from the left side of the engine. It continued to run as I looked for leaky fluid, but then died shortly after backing it up and won’t start now. The oil light comes on when I try to start it, no noise or anything else. 
      No blown fuses that I can find.
×
×
  • Create New...