-
Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
-
Similar Topics
-
By mga
I just brought home a used 2005 Yamaha Big Bear 400 4x4. It needs front wheel bearings, and a new choke cable. I think i can handle those two items. However, when i went to look at it, it ran good, shifted good, brakes all workds great, but at home when i started it, it would idle nice, but when i gave it gas it seemed like it was flooding out and would die. If i just gave it a little throttle it built up RPMs but any more throttle it began dying out again.
any suggestions why it's doing that?
I'm looking for a service manual, but forum rules say i have to make 10 posts..lol
oops...i just realized i posted in the wrong section of the forum!!
-
By newfielander
Hi guys, I really have my hands full here with my 2014 Polaris Sportsman 550 X2, Is it possible all these issues can be related and traced back to something electronic? Its so confusing because sometimes the PS do work, sometimes the 4 wheel drive do work, sometimes the ATV starts at the turn of the key, other times I have to cross out the starter solenoid to start the ATV, Sometimes the 4 wheel drives works fine in reverse, other times only in forward, then other times no 4 wheel drive at all (meaning i can see the front drive shaft going into the front end and its turning but neither wheel is pulling, then other times only 1 wheel is pulling) Would a faulty voltage regulator cause these issues? I hate to pull my front end off the ATV if its something electronic! I cannot simple replace the EPS unit unless i was 100% sure it was quit. But when i see that it works sometimes, I'm not convinced that the unit needs to be replaced, and especially when all these other issues are in my opinion electrical related. I have tried to clean all the plugins that i know for............ Is there anything I can do to figure this out?
Any suggestion is MUCH appreciated.
Thanks
-
By M4ATVfun
I'm trying to fix a 1986 Yamaha yfm80. I suspect that the CDI is bad since I get spark but my timing is 60 degrees advanced, I can't find a new or reasonably priced used CDI. I was wondering if anyone knows of an alternative CDI that would work? If a CDI from a later year YFM80 could be spliced into the ATV or perhaps from different Make/model ? that would produce the correct timing for this engine
-
By trx125flip
yay forum stuff again... really needing a 87 trx125 service manual.. if anyone has one without a dead link that would be super!
-
By jamison1969
I have a 97" polaris sportsman 500 and the 4 wheel drive wont work, it just didnt work one day. I dont know when or why it went out. It has a 4 wheel drive button on the handle bars and it is on and i have turned it on and off but no go............ any thoughts or ideas, please help. I need it for sat. i will never get out on this small lake for ice fishing with out my wheeler, thanks in advance jamie.
-
-
-
Similar Tagged Content
-
- 9 replies
- 7,268 views
-
- 2 replies
- 5,422 views
-
- 10 replies
- 5,621 views
-
- 0 replies
- 1,697 views
-
- 1 reply
- 5,072 views
-
-
Gallery Images
-
1 -
0By dirtmerchant42,
-
5
-
5By mannyortiz7,
-
2
-
0By SeanKing,
-
4
-
2By CK1999_400ex,
-
4
-
4
-
0
-
0By George Henry,
-
1
-
7By nyatvrida91,
-
4
-
0
-
3By mannyortiz7,
-
0
-
3By blahhhh,
-
4By mannyortiz7,
-
-
Recently Browsing 0 members
- No registered users viewing this page.
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.