-
Popular Now
-
Similar Forum Topics
-
By quadfamily
Hello everybody
I am in search of an lt 80 kids quad rear swing arm. The one on my kids quad broken and am looking for replacement. If you guys know of any upgrades or swaps I could od I would appreciate that also.
Thanks
-
By skeeter45
Guys, having trouble finding the correct rubber boot for my big Bear. I've ordered 2 of them and both are wrong. The old one was 4 inches across on the end with the tabs. New ones are 5 inches across. Much to big to fit properly. TIA Hope someone has an idea. -
By Arizona
Went shopping on Saturday, picked up another Kawasaki Bayou 220 and a Yamaha Timber Wolf 250
I really should sell some of these but they are a lot of fun to find, fix and ride
Of course neither of them run but that's part of the fun! Az
-
By MarkinAR
On a 93 Kodiak, and I am sure BigBear behind and below the clutch pack sits a claw of a piece. It has a stack of washer bearing washer, claw, 3 bearing plate, then stabilizer fork that sits on a shaft. What does that bad boy do?
-
By Tiffany Rowland
I bought an 07 honda trx400ex for my daughter 11th birthday. I've been having alot of fun fixing it up but after reading some of the posts about safety I think I may have gotten a little carried away. I put an exhaust on that added 10hp, a k&n performance filter, new carb, a stage 3 rev box and coil, and I wrapped the exhaust. The top speed started out at 92mph and we're well above that now. My main concern, though, is low end throttle. Is there any way I can do something thate will decrease the rate of acceleration without taking off the modifications I've done? She's super cautious and won't go over 10mph but I'm worried that she may have a hard time controlling it after these last few upgrades.
-

Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.