HD Dune Video from Oregon
-
Similar Forum Topics
-
By tflack500tbx
Background,
This winter (Dec.) I was plowing and everything just died, just quit. No lights, no pull start, No nothing. I've had this problem before and I changed the voltage reg and it ran fine for over a year. Then this. So I changed it again, thinking this was the same problem. Tried to start it and a small pin hole in the CDI appeared with electrical smoke.
Months go by and I finally decide to just replace parts (I'm Horrible at electrical issues). I changed the stator, new CDI, new Voltage reg, new starter solenoid, tested the starter (prefect), charged the battery.
Went to start it and the solenoid rapidly clicked. All the dash lights on, headlights work. Pull stared it and it fired right up no issues. Looked into the rapidly clicking starter solenoid and it was not enough juice in the battery. Took the battery completely out and hooked up a jump box to it turned the key, light on, everything looks good. Pushed the starter button and it fired right up ran great. Turned it off to test it again, Turned the key and nothing. No dash lights nothing. Took the jump box off and pulled started it. Started it right up. Re-hooked the jump box, still nothing.
Any Ideas?
-
By mikeexplorer
I took this video back in 2007. Recently the trail (old railroad grade) I was riding was converted into a walking trail (obviously no more ATV riding on it) 👎 I dug up this old video and put it together since it shows the entire section and what it used to look like. The quality of the video is lacking, but this was from 18 years ago. Image stabilization didn't exist back then so I wore the camera on my helmet. (mounted to the quad was useless with all the shaking) so there is some annoying frames of me looking around. I noted any historical items from the railroad in the video. There is a section where the railroad grade is wiped out due to erosion so I had to jump off it and ride an abandoned road for a section to get around it.
-
-
-
By DaveswMN
Pulled my '86 Moto4 out of shed where it sat for 20 years. I knew it smoked. checked it over a little put in gas and it fired right up!!
Drove about 100 yards, ran about half throttle wouldn't idle. Put on somenew parts, jug/piston and rings, carb and valve seals.
'went together ok, tuned it over by hand about 6 revs whick went well. Hit the starter it fired for about 6 revs and quit. tried it again fired once and then th sound of something slipping like maybe chain slipping over spoket.
Took cover off to watch cam sproket, hit starter again, heard same noise and the cam sproket was not turning but jumping a bit. Chain was still tight. You will probably tell me I need to split the lower case but hoping there mightbe something else.
I don't fully understand the chain tightener, the plunger only moves about 1/4 inch, should it move much more than that when off the motor and compressing it by hand?
Thanks for any thoughts.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.