-
Do you own an ATV or UTV? Join our Forum!
Join QUADCRAZY ATV Forum today for FREE! We keep these forums clean and user friendly. All first posters will have to wait to have their content reviewed and approved. Once your first post is approved, you will no longer need to got through an approval process. To gain immediate approval and a NO ADS experience, consider subsribing to our Premium Membership.
-
Similar Topics
-
By alexwv1863
Hey everyone, I have an issue with my dad's 03 Yamaha Kodiak 400. It had been running great but he left it sitting for a short amount of time. When he started it, it ran fine for a little bit but all of a sudden it quit taking gas. I thought it may have been the carb because it him not running it. The carb ended up being pretty clean. He put it back on and after taking it off and cleaning again, I'm beginning to wonder what it could be. It'll start and idle just fine, but when you go to give it throttle, it'll die out. It sounds like it's not getting air right but idk where to look or what else it could be. I'm stumped and need to figure this out before I go crazy. Anyone have any ideas???
-
By Whiterabbit
New to me Quest 650 with the Rotax engine, auto trans. Looking at the starter solenoid there are the usual wires, Batt+ in and Batt+ out to starter and the 2 lil wires to the ign start button but there is a factory box with 2 lil wires coming out mounted to the frame next to it, one wire is connected to one of the large Batt terminals (12 o-clock position in pic). The other wire from the box is just dangling out in space. I can't find where that loose wire goes and what the **** the lil' box is. 😆 Need some insight please.
-
By ggreen
Sorry if this is in the wrong section,I didn't really consider it technical or needing advice. 2006,Linhai 300cc.What I was hoping was to find someone with the starter idler gear pin length and diameter. I've had the cover off alot of times and never realised there should be a pin from the case that meets the cover holding the starter gear in place. Now,a deepwell 1/4 in drive,5/16 deep well sits in the pin holes perfectly. Should I cut a lock ring groove in the end of it like a factory pin? I was thinking of just tack welding a washer to the end?
-
By Cheetah
Hello,
recently I removed my starter because it was to slow so before buying a new one I thought cleaning it. So I did and it did went much better.
The thing is I replaced it exactly as it was but since then the starter goes freely like there’s no dentelywheels.
Did I do something wrong ?
-
By oxidized_black
Yamaha ATV manuals are located in the downloads section here at QUADCRAZY.
Please visit the downloads section at https://www.quadcrazy.com/files/
Get 15% at emanualsonline.com with coupon code EMOAFF
Get 20% at emanualsonline.com with coupon code BLAZE and $50 purchase
Clymer ATV Manual - Yamaha Raptor 700R
-
-
Similar Tagged Content
-
- 3 replies
- 471 views
-
- 3 comments
- 752 views
-
- 1 reply
- 2,266 views
-
- 1 reply
- 3,799 views
-
- 0 replies
- 2,106 views
-
-
Gallery Images
-
Recently Browsing 0 members
- No registered users viewing this page.
.jpg.dae6846dd3f898104f86ce4b067428a0.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.