Quantcast
Jump to content


1992 Suzuki LT-230E running poorly, help please!!!


zeigfeld

Recommended Posts

hey there i spent all day trying to get my quad to start but it would not we tried pulling it after we fixed the pull start tried the jumper cables to the starter and even tried to push it and drop the gear but it would run. bog pick up bog pick up then die the longest i lasted was a munite it sounds like it is flooding out but im not sure maybe not getting enough gas but its back fireing like crazy sounds like gun shots. when its started and boging i put new coil and wire to cap and cap cleaned the carb really good but still not running the quad still has tones of compresion but refuses to run any ideas?

Edited by zeigfeld
Link to comment
Share on other sites

Yes, the key and kill switch must be on to pull start or compression start the machine.

First, check the valve lash and the flywheel key. If all is ok there, take the carb off and check for deposits, damaged diaphragms or a sticking float. Have you tried a new spark plug? I take it the machine is getting spark?

Edited by DirtDemon
Link to comment
Share on other sites

Usually 1 1/2 to 2 1/2 turns out from seated. A good way to get it set properly is to, with the engine running, turn the screw in the screw until the engine begins to stumble and run poorly. Then slowly turn the screw back out untill the engine idle reaches it's highest point, then re-adjust the idle setting if needed. If you have to turn the screw out more than 2 1/2 turns, you are probably running to lean on your pilot jet. If you turn it out less than 1 1/2 turns, then your pilot is too rich.

Link to comment
Share on other sites

i got my quad running for like 1 munite but to keep it going i have to put my thumb on the throttle and it just keeps back fireing which i think is lean pop but im taking it to the shop today and if i can aford it ill let you all know whats wrong if not anyones info would be nice

Edited by zeigfeld
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Brantley11
      Hey everybody,
       
      My proficiency is with Hondas and Yamahas make me see RED!
       
      This bike is my brother in law's, it has 1199 miles on it and went from running great to dead with no start. Every once and a while it will start and sputter for 2 seconds. It is extremely sporadic when it fires but never runs for longer than 3 seconds. 
       
      Here is where we sit:
      Brand New Fully Charged battery
      Carb was cleaned with air hose and carb cleaner then into the ultrasonic cleaner with Aircraft aluminum cleaner
      New Shindy Carb kit (made in Japan version)
      Cleaned out petcock and gas tank
      New 93 Non Ethanol Gas
      New Spark Plug
       
      It gets a spark through the spark test light every time
      Bluish white spark
      When holding the spark plug 1/4" - 3/8" away from head it will jump and spark to the head
      Good Compression
       
      Here are the readings:
       
      Pickup Coil 519 Ohms (range 459-561)
      Charging Coil 266 Ohms (range 270-330)
      Lighting Coil 0.700 (range 0.702-0.858)
      Spark plug Cap 10.58 Ohms (10kohms
      Ignition Coil Primary Coil 0.5 ohms (range 0.18-0.28 ohms)
      Ignition Coil Secondary Coil 8.20 kOhms (range 6.32-9.48 kOhms)
       
      Would y'all think stator and pick up coil, rectifier or CDI are the culprit?
       
    • By mga
      I just saw a video on TikTok where some guy took the rear end off an ATV and bolted on a roto tiller in place of rear wheels. I wish i saved that video to post here....good thing it was 4 wheel drive...lol but, it seemed to work.
      I'm not sure how he made it bolt on to the drive....
    • By 86ccord
      Starting this build thread to keep up with everything on my build and hope to motivate someone!
       
      I picked up this 2008 Yamaha Big Bear 250 2 weeks ago. A guy that I hunt with parked it at the hunt club for a year or so before I asked him if he wanted to sell. He said " fill my feeder and throw some batteries in my cameras, and you can have it". Sounds like a deal to me! 
      I have attached some pictures of how it sat under a tarp in the woods and when I got it home and cleaned up a little. 
       
       



    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next



×
×
  • Create New...