Quantcast
Jump to content


2000 Suzuki King Quad 300 Snorkel Problems


Recommended Posts

Ok I have a 2001 king quad 300 it crapped out about two months ago rite before I put my snorkle kit on. Well I had it all taken appart putting the snorkle on and I decided to go ahead with the kit before fixing the original problem ( yes I know bad idea ) it was running before the kit. It would idle fine but when u reved it up it bogged out and backfired with white smoke common sighns of flooding out so I adjusted the carb after cleaning it 12 hours in soapy water and thorough cleaning on the outside and inside it still ran the same I bought a carb kit and still the same I went back throughout the carb and it was spotless I checked the float and it is fine no spots or anything so I adjusted the fuel to air screw and the needle with no luck I then replaced my fuel pump ( because I noticed fuel running out the back ) still ran the same. I recently had it running for a while putting around in low speed ( ran fine ) give it gas and it boggs out ( too much fuel) I noticed when it boggs out there is air coming out of the snorkle like a blowback I have tried reducing the air intake by covering the snorkle and it has no effect. Im at a los and due to our wonderful economy and my small town job im unable to send it to the shop so im here.

Link to comment
Share on other sites

No but i had planned on checking the spark till i lost all my tools out the back of my truck lol so i have to get more tools .....go figure! Lol thank you for the comment

LOL..that happens to me, I loose tools all the time. They are usually lying somewhere because I forget to put them back where they belong. Then I need something, and it's an hour to find a freakin tool! :laugh:

Link to comment
Share on other sites

Lol well i left my tools at a convenience store as i unloaded a lawnmower, figures with my luck. I have to buy a new battery mine has crashed. It was weird because the starter didnt want to turn it over if the choke was closed or if u gave it any gas during cranking it over it would stop and start clicking. It did that even with the atv battery and a marine battery and a running truck lol. Im yet again stumped

Link to comment
Share on other sites

  • 5 weeks later...

check you petcock. there is a vacuum line that runs from there. the diaphragm breaks and leaks, when you start the motor the vacuum line sucks gas, there it runs very rich. shut off gas, drain the carb. and put vise-grip or clamp on the vacuum hose(close it some how).turn on gas and start it. i am 95% sure this is the problem.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By bob2007
      Hy there great to be able to communicate with people having knowledge I have a continuous problem with a leaking carburetor and I just saw a small rubber hose detached from the bottom of the carburetor and i cannot find were it should be attached and how the two side should be affixed to the carburetor any suggestions as i cannot find a description plan on it thank you Bob
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By cavry
      Wiring shows White and Brown to solenoid blades. Then a black wire from starter circuit relay to solenoid. I am confused,  where is that black wire supposed to connect?
      Thanks for any help
      Cavry
    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
    • Best Fit and Protection Guaranteed for all your cars, trucks, boats, jet-skis and more. Visit SealSkinCovers.com. Seal Skin Supreme Covers come with a Lifetime Warranty. Free Shipping!
    • By jatho
      Has anyone else had an issue on older king quads where the oil would leak from the top of the head (due to a failed gasket) and drip onto the hot exhaust? Mine got so hot one time it caught fire. Just wondering if this is a common issue, as I've seen the same thing happen on multiple bikes that were the same model. 
×
×
  • Create New...