Quantcast
Jump to content

Recommended Posts

Posted

My 2000 Suzuki quad king 300 4X4 starts great and runs great but after I drive it for a while it won't take it's gas and it won't move. If you turn it off it will start and idle fine til you give it the gas and it won't take it's gas again. You can turn it off and it will run fine again but it won't take it's gas again. This will go on for sereral restarts and finally it will run fine again, but after awhile of driving it will start this process all over again.Does anyone have any suggestions what it is

  • 2 months later...
Posted

check fuel line, petcock and also gas cap and line out of it. if clogged you get vapor lock after a few minutes. not enough gas gets sucked into carb/engine then.

  • 4 months later...
  • 2 weeks later...
Posted
My 2000 Suzuki quad king 300 4X4 starts great and runs great but after I drive it for a while it won't take it's gas and it won't move. If you turn it off it will start and idle fine til you give it the gas and it won't take it's gas again. You can turn it off and it will run fine again but it won't take it's gas again. This will go on for sereral restarts and finally it will run fine again, but after awhile of driving it will start this process all over again.Does anyone have any suggestions what it is
Safety fuel petcock is the main fault vacuum operated fuel shut off bad fuel mixed with ethanol stuck choke cable my main was vacuum petcock will allow fuel into carb. long enough to starts backfire run out of fuel even tank full dealers charge anywere $112 part plus labor best is go online bangood.com 01 raptor fuel petcock $6.99 its two screws and a vacuum plug on carb problem solved also stay away from fuel with ethanol it sits week or two gums up your whole fuel system.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Rockbottom
      2008 400 big bear was running now will not start
      have power to relay, in neutral, press start have power to starter but nothing happens starter does not turn
      i have good ground at battery to frame and added ground from wire harness to frame beside batter/ frame ground
      blue white wire to cdi has power with key on
      I believe the neutral lock out is working since is was before i shut it down
      if i put  it in gear and hit the start button with key on the relay does not click or send power the starter
      The 3 wires at the relay have power with key on
      What should i test next?
      thanks ahead
    • By Mister907
      Hi guys, I have a 2004 big bear 400. Last winter while plowing the driveway, I heard a loud pop from the left side of the engine. It continued to run as I looked for leaky fluid, but then died shortly after backing it up and won’t start now. The oil light comes on when I try to start it, no noise or anything else. 
      No blown fuses that I can find.
    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By rjsummer
      I just bought a 1984 Suzuki LT185 ATV and am looking for the OWNER’S manual. ( not a service manual) 
      I contacted Suzuki Canada but they have no paper or digital copies in their archives. 
      Does anyone possibly have a digital copy they’d be willing to share? 
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
×
×
  • Create New...