Do you own an ATV or UTV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
- 2000-2005 Yamaha Big Bear Kodiak YFM 400 Service Manual
Similar Tagged Content
Hello folks, I have a yamaha timberwolf 250 motor I'm putting into a tri moto 200 frame and need some help with the wiring for it. The wiring harness I got with the motor has been damaged and missing a small section so my issue is that I have 3 white wires coming from the stator assembly which connect into another 3 white wires on the voltage regulator. My question is does it matter which of those white wires go connected together or are each of the white wires different and need to be connected to the appropriate wire on the voltage regulator. Any advice or help is appreciated. Thanks.
My 98 grizzly needs a cdi and I refuse to pay $200 for a used one. Will the cdi unit for CDI Box For Yamaha Kodiak 400 YFM400 2001 2002 Warrior 350 YFM350X 1997-2001 work on a 98 grizzly ?
Hi i bought my first atv last week, mostly for plowing. its a 94 yamaha big bear 350 4x4, with plow, new front axles, carb rebuild and some other stuff for $900. in todays prices, i think it was a pretty good deal. I plan on tearing it down and doing a semi restoration in the summer. its been clearly neglected so i suspect i will need to do a fair amount.
1. parts and manuals, so far i know it needs front shocks, tie rods, brakes, cables, lots of small stuff, whats your guys favorite online atv parts store? where can i find a good repair manual?
2 - starts and drives great, shifts a bit hard? not sure whats normal because i dont have a point of referance. i have to almost lean back in the seat and lever my foot up to get it to shift, seems like there is either alot of play in something (shift lever itself is tight) or there is a long travel, or it just dosent want to shift. also the hi / low / reverse lever needs to go past the gate a bit to actually shift into gear, and seems to need me to shift into nutral before shifting into reverse (not sure what your supposed to do). also wondering a bit about the history of the machine, because the plastics have a slot for a dash mounted shifter, but the one on it is a gated shifter right above the pull starter.
3. seat and plastics repair, seat is quite torn up with a seat cover over it, plastics are pretty cracked up, these items i havent found replacements for for any reasonable price, i dont care a whole lot about asthetics but whats the best way to functionally repair these things? is there reasonably priced replacements somewhere? i plan to bedline the whole thing after im done.
4. there was no title, but i did get a bill of sale, will it be difficult to get it titled / registered? (im in mn)
thanks in advance for your help, looking forward to being part of the community