Search the Community
Showing results for tags '660r'.
-
Hey Frank I posted some pictures of my stator from my Raptor660r and I need some help,here are some pics of the numbers I got from the stator the 494 is ok,that's from the white/red & white/green wires but from the white to white I was getting no reading and from the blue and red wires also no reading, so it's most likely done right? Sent from my SM-N950U1 using Tapatalk
-
I posted a question last fall to try a figure out why my '05 raptor 660 runs so poorly after a local shop worked on it. They insalled the jet kit and cdi. It starts cutting out past about 3000 rpm. It feels like it is starving for fuel. Does not cut out at exactly the same rpm but close. If you play with the throttle (ease into it back and forth a little) it will eventually rev up but still cuts out when you hammer it!! This only happens when riding it... in neutral it revs straight to govener with no hesitation. ADD ONS gytr jet kit k&n filter D&G exhaust(slip on) CDI box (Ricks motorsports hot shot) THINGS I HAVE TRIED replace cdi box new jets- stock runs 140 & 145, shop installed 145 & 150, I installed 150 & 155 (dual carbs) Adjusted air fuel mix a thousand times!!! removed parking brake saftey switch tested coil THEN I GAVE UP!!! SO DID ALMOST ALL THE SHOPS IN TOWN!!!!
-
I have a raptor 660r and I have adjusted the clutch because initially my issue was that when I put it in reverse it would bogg down and die out because it acted like it was not all the way in gear. Then my reverse works after adjusting the cable by the engine and now I am noticing that when I give it alot of gas it slips and does not have all the torque. I also noticed this when I was pulling someone out it was slipping real bad. Anyone have any suggestions?
-
Ok here goes.... I was riding and stalled out and my raptor wouldn't start up. I found the battery cable had broken off the terminal. I held it on to start it and get it back to the house. I put the battery cable back together and it wouldnt start. I did some troubleshooting and the battery is good, I can force the starter to turn over but it wont start because of the electic circuit not being right. I can not even get the neutral light when it is in neutral. I checked the 2 fuses on the starter block. Any suggestions?
- 13 replies
-
- 660r
- electrical
-
(and 3 more)
Tagged with: